Monatomic layers of graphite are emerging as building blocks for novel optoelectronic devices. Experimental studies on a single graphite layer (graphene) are today possible since very thin graphite can be identified on a dielectric substrate using a normal optical microscope. We investigate the mechanism behind the strong visibility of graphite, and we discuss the importance of substrates and of the microscope objective used for the imaging.

On the SiC(0001) surface (the silicon face of SiC), epitaxial graphene is obtained by sublimation of Si from the substrate. The graphene film is separated from the bulk by a carbon-rich interface layer (hereafter called the buffer layer) which in part covalently binds to the substrate. Its structural and electronic properties are currently under debate. In the present work we report scanning tunneling microscopy (STM) studies of the buffer layer and of quasi-free-standing monolayer graphene (QFMLG) that is obtained by decoupling the buffer layer from the SiC(0001) substrate by means of hydrogen intercalation. Atomic resolution STM images of the buffer layer reveal that, within the periodic structural corrugation of this interfacial layer, the arrangement of atoms is topologically identical to that of graphene. After hydrogen intercalation, we show that the resulting QFMLG is relieved from the periodic corrugation and presents no detectable defect sites.

The structural dynamics of ultrathin polymer films of poly(ethylene terephthalate) capped between aluminum electrodes have been investigated by dielectric relaxation spectroscopy. A deviation from bulk behavior, appearing as an increase of the relaxation time at a fixed temperature, is observed for films of thickness below 35 nm. The slowing down acts as a constant shift factor independent from the temperature, and the fragility is constant. The interfacial energy between aluminum and poly(ethylene terephthalate) is calculated to be 3 mJ/m2, confirming a strong interaction between polymer and substrate, which leads to the presence of a layer characterized by a reduced mobility at their interfaces. We proposed a mathematical schematization of a multylayer model that allowed qualitative reproduction of the observed thickness dependences of the static and dynamic properties. In terms of such a model, the upper limit for the thickness of the reduced mobility layer was estimated as 20 nm. The conditions to extend the proposed model to different observables are finally suggested.

Progress towards green and autonomous energy sources includes harnessing living systems and biological tissue. It is recently discovered that the cuticle‐cellular tissue bilayer in higher plant leaves functions as an integrated triboelectric generator conductor couple capable of converting mechanical stimuli into electricity. Here, it is investigated for the first time, in detail how charge generation at the living plant leaf occurs, and it is shown how whole plants could be used in plant‐hybrid wind‐energy harvesting systems. The charge accumulation and compensation in and ex vivo on Rhododendron leaves by Kelvin force microscopy is verified, revealing that charges are induced and transported in living plant tissue whereas charges remain unbalanced and trapped on dead leaves of the same species. A distinct sensing functionality and opportunity to upscale power output is given as electrical signals are species, touch‐material, and dose‐dependent and scale with frequency, impact force, and area. It is shown that also purely natural mechanical stimuli by wind or self‐touching of leaves are converted into electrical signals by a triboelectric mechanism. The entirely plant‐enabled and autonomous energy conversion can be used to directly drive light emitting diodes, charge a capacitor, and harvest wind‐energy with promise for new energy sources based on the Plant Kingdom.