The article describes a large scale of rectangular light source design comprised of six different types of high-power light emitting diodes (LEDs). The new modular based on the LED solar simulator with the greatest size using the symmetrical LED positioning method. The experiment provided the irradiation of the solar simulator in the class AAA over 416 cm 2 . The rectangular LED module illustrated the uniform distribution of the irradiance across the sample plane area. It reached the class A of air mass 1.5 for global spectrum (AM1.5G) (1000 W/m 2 ) covering the 400 nm to 1100 nm wavelength range. The proposed system offered a spectral match of 100%, the temporal instability equivalent to 0.611%, and a non-uniformity of irradiance less than 2%. When the proposed solar simulator was tested in solar cell characteristics under standard test conditions, it was found that the short circuit current error between the sample solar cell under our solar simulator and the standard solar simulator was less than 0.538%. This proposed design is, therefore, an interesting design that can be applied easily and economically further for large scale solar simulators with its modular system.

<span lang="EN-US">A phosphor-converted light-emitting diode (LED) solar simulator is an illuminance device that produced irradiance intensity and spectral close to the sunlight. It is determined as spectral mismatch, non-uniformity of irradiance, and temporal instability. This paper has improved the LED solar simulator (LSS) system to have a spectral distribution consistent with the AM1.5G spectrum at 100%. It was developed as a new prototype to have the AAA class spectral characteristics, time instability, and inconsistency according to IEC 60904-9. The results showed that an optimal approach was to use phosphor-converted natural white LED (pc-nWLED), combining a monochromatic near-infrared (NIR) (730, 800, 850, 940, and 1,000 nm) as well as the proposed LSS system capable of generating 1,000 W/m² irradiation over the test plane of 125×125 mm and operated continuously in a constant temperature LED state for at least 2 hours, therefore suitable for demonstration of solar cell features under standard test condition (STC) in the laboratory.</span>

Solar simulator is used to analysis characteristic of the solar cells. The non-uniformity is its major performance. The traditional non-uniformity measurement calls single detector method. The paper’s objective is to design and construct an array detector scanning system and to determine the optimal scanning time to achieve the lowest uncertainty. To investigate the non-uniformity by our proposed method and the traditional method, our detector consisted of eight photodiodes mounted on an arm of a linear motion lead screw to guide the detector scaning onto the lighting area. A microcontroller applied for controling and measuring light irradiance in 64 points corresponding to IEC 60904-9 standard. The results showed that the array detector scanned at a speed of 33.33 mm/s to obtain the non-uniformity with the lowest uncertainty, less than 0.6%. Analysis results of the non-uniformity obtained from our system on the test areas of (mm×mm) 156×156, 166×166 and 200×200 compared with the single detector. It showed that the mean absolute error was 1.27. Our system provided a lower uncertainty than the traditional method. The measurement accuracy was acceptable. The advantage is for testing on different test areas within a single device. The measurement time is around 1/32 of the traditional method.