The atmospheric contribution constitutes about 90 percent of the signal measured by satellite sensors over oceanic and inland waters. Over open ocean waters, the atmospheric contribution is relatively easy to correct as it can be assumed that water-leaving radiance in the near-infrared (NIR) is equal to zero and it can be performed by applying a relatively simple dark-pixel-correction-based type of algorithm. Over inland and coastal waters, this assumption cannot be made since the water-leaving radiance in the NIR is greater than zero due to the presence of water components like sediments and dissolved organic particles. The aim of this study is to determine the most appropriate atmospheric correction processor to be applied on Sentinel-2 MultiSpectral Imagery over several types of inland waters. Retrievals obtained from different atmospheric correction processors (i.e., Atmospheric correction for OLI 'lite' (ACOLITE), Case 2 Regional Coast Colour (here called C2RCC), Case 2 Regional Coast Colour for Complex waters (here called C2RCCCX), Image correction for atmospheric effects (iCOR), Polynomial-based algorithm applied to MERIS (Polymer) and Sen2Cor or Sentinel 2 Correction) are compared against in situ reflectance measured in lakes and reservoirs in the Valencia region (Spain). Polymer and C2RCC are the processors that give back the best statistics, with coefficients of determination higher than 0.83 and mean average errors less than 0.01. An evaluation of the performance based on water types and single bands-classification based on ranges of in situ chlorophyll-a concentration and Secchi disk depth values-showed that performance of these set of processors is better for relatively complex waters. ACOLITE, iCOR and Sen2Cor had a better performance when applied to meso-and hyper-eutrophic waters, compare with oligotrophic. However, other considerations should also be taken into account, like the elevation of the lakes above sea level, their distance from the sea and their morphology.

No abstract

No abstract

Freshwater quality maintenance is essential for human use and ecological functions. To ensure this objective, governments establish programs for a continuous monitoring of the inland waters state. This could be possible with Sentinel-2 (S2) and Sentinel-3 (S3), two remote sensing satellites of the European Space Agency, equipped with spectral optical sensors. To determine optimal water quality algorithms applicable to their spectral bands, 36 algorithms were tested for different key variables (chlorophyll a (Chl_a), colored dissolved organic matter (CDOM), colored dissolved organic matter (TSS), phycocyanin (PC) and Secchi disk depth (SDD)). A database of 296 water-leaving reflectance spectra were used, as well as concomitant water quality measurements of Mediterranean reservoirs and lakes of Spain. Two equal data sets were used for calibration and validation. The best algorithms were recalculated using all database and used the following band relations: SDD, R560/R700; CDOM, R665/R490; PC, R705/R665 for S2 and R620, R665, R709 and R779 for S3, using a semi-analytical algorithm; R700 for TSS < 20 mg/L and R783/R492 (S2) or R779/R510 (S3) for TSS > 20 mg/L; and for Chl_a, the maximum (R443; R492)/R560 for Chl_a < 5 mg/m3 and R700/R665 for Chl_a > 5 mg/m3. A preliminary test with a satellite image in a well-known reservoir showed results consistent with the expected ranges and spatial patterns of the variables.

<p>Assessment of rural fire severity is fundamental to evaluate fire damages and to analyze recovery processes in a low-cost and efficient way. Burnt areas covering shrubs and grasslands were estimated in more than 30,000 km²  in Argentina from December 2016 to January 2017. The study area presented in this work is located in the South of the Buenos Aires province, and it covers a semiarid area with the presence of xerophilous shrubs and grasslands. This is one of the most abundant ecosystem in Central and Southern Argentina. Field campaigns were carried out over the area affected by the fire in order to georreference the burnt plots and characterized the fire severity in 5 levels. The objective of this work is to analyze the feasibility of new satellites Sentinel-2 for fire studies, as well as provide a comparison to Landsat-8 derived results, because this mission has been one of the most used in it. Pre-fire and postfire Sentinel-2 and Landsat-8 imagery were used to analyze different band combinations to compute a Normalized Difference Spectral Index (NDSI), as well as the difference of this index before and after the fire (dNDSI). Results show a significant correlation (R² =0.72 and estimation error of 0.77) between dNDSI derived from Sentinel-2 and the severity levels obtained in the field campaign using bands 8a and 12 (NIR and SWIR), the same bands as used in the Normalized Burn Ratio (NBR). Moreover, results derived from Sentinel-2 are better than results derived from Landsat-8 (R² =0.63 and estimation error of 0.92). Furthermore, it is observed that the correlation is improved when Sentinel-2 bands 6 and 5 (located in the Red-Edge region) are considered (R² =0.74 and estimation error of 0.76). An inverse correlation has been observed between the recovery of vegetation four months after the fire and the fire severity level.</p>