The provision of clean water is a global challenge, and membrane filtration is a key technology to address it. Conventional filtration membranes are constrained by a trade-off between permeance and selectivity. Recently, some nanostructured membranes demonstrated the ability to overcome this limitation by utilizing well-defined carbon nanoconduits that allow a coordinated passage of water molecules. The fabrication of these materials is still very challenging, but their performance inspires research toward nanofabricated membranes. This study reports on molecularly thin membranes with sub-nanometer channels that combine high water selectivity with an exceptionally high permeance. Carbon nanomembranes (CNMs) of ∼1.2 nm thickness are fabricated from terphenylthiol (TPT) monolayers. Scanning probe microscopy and transport measurements reveal that TPT CNMs consist of a dense network of sub-nanometer channels that efficiently block the passage of most gases and liquids. However, water passes through with an extremely high permeance of ∼1.1 × 10 mol·m·s·Pa, as does helium, but with a ∼ 2500 times lower flux. Assuming all channels in a TPT CNM are active in mass transport, we find a single-channel permeation of ∼66 water molecules·s·Pa. This suggests that water molecules translocate fast and cooperatively through the sub-nanometer channels, similar to carbon nanotubes and membrane proteins (aquaporins). CNMs are thus scalable two-dimensional sieves that can be utilized toward energy-efficient water purification.

Under the influence of homogeneous, rotating magnetic fields, superparamagnetic beads can be assembled into one- and two-dimensional superstructures on demand and used as dynamic components in microfluidic systems for colloidal separation. In this paper, the influence of the magnetic field strength and the rotation frequency on the device efficiency is studied. The optimum region is found to be between 100 and 200 rpm for a magnetic field strength of 330 Oe, while the highest value for separated mass per time (28 pg s(-1)) is achieved for a flow velocity of 370 μm s(-1) at a magnetic field strength of 690 Oe. Furthermore, the employment of superparamagnetic beads as a continuous-flow bioseparation device is shown in a proof-of-principle study.

The determination of the negative ion yield of 2′-chloro-1,1′-biphenyl (2-Cl-BP), 2′-bromo-1,1′-biphenyl (2-Br-BP) and 2′-iodo-1,1′-biphenyl (2-I-BP) upon dissociative electron attachment (DEA) at an electron energy of 0 eV revealed cross section values that were more than ten times higher for iodide loss from 2-I-BP than for the other halogenides from the respective biphenyls (BPs). Comparison with dissociative ionization mass spectra shows that the ratio of the efficiency of electron impact ionization induced fragmentation of 2-I-BP, 2-Br-BP, and 2-Cl-BP amounts to approximately 1:0.7:0.6. Inspired by these results, self-assembled monolayers (SAMs) of the respective biphenyl-4-thiols, 2-Cl-BPT, 2-Br-BPT, 2-I-BPT as well as BPT, were grown on a Au(111) substrate and exposed to 50 eV electrons. The effect of electron irradiation was investigated by X-ray photoelectron spectroscopy (XPS), to determine whether the high relative DEA cross section for iodide loss from 2-I-BPT as compared to 2-Br-BP and 2-Cl-BP is reflected in the cross-linking efficiency of SAMs made from these materials. Such sensitization could reduce the electron dose needed for the cross-linking process and may thus lead to a significantly faster conversion of the respective SAMs into carbon nanomembranes (CNMs) without the need for an increased current density. XPS data support the notation that DEA sensitization may be used to achieve more efficient electron-induced cross-linking of SAMs, revealing more than ten times faster cross-linking of 2-I-BPT SAMs compared to those made from the other halogenated biphenyls or from native BPT at the same current density. Furthermore, the transfer of a freestanding membrane onto a TEM grid and the subsequent investigation by helium ion microscopy (HIM) verified the existence of a mechanically stable CNM created from 2-I-BPT after exposure to an electron dose as low as 1.8 mC/cm2. In contrast, SAMs made from BPT, 2-Cl-BPT and 2-Br-BPT did not form stable CNMs after a significantly higher electron dose of 9 mC/cm2.

The local work function is an invaluable feature for the specific analysis of the influences of atomic and molecular nanostructures on each other as well as the underlying surface. Adsorbate molecules can modify this parameter by introducing an electrical dipole moment, which affects the local contact potential. This can be accessed by Kelvin probe force microscopy (KPFM). In this paper, we demonstrate, by combining highly resolved topographic atomic force microscopy (AFM) data with the simultaneously acquired local work function signal, how each of these channels yield one angular coordinate, resulting in the three-dimensional determination of surface molecular dipole orientations. We studied the adsorption of terphenylthiol (TPT) self-assembled monolayers on Au(111) and Ag(111), as it is relevant in the light of electron radiation-induced transformation to carbon nanomembranes. We present noncontact AFM data combined with frequency-modulated KPFM in ultrahigh vacuum at room temperature without any kind of deliberate tip functionalization. Our results show a surface coverage-dependent Langmuir-like evolution of phases with domains of flat lying as well as with upright molecular arrangements. Whereas we found an almost complete vertical orientation on silver, the orientation on gold was found to be tilted, corresponding to sp- and sp3-hybridized bond angles, respectively.

Ultrathin membranes with subnanometer pores enabling molecular size-selective separation were generated on surfaces via electron-induced cross-linking of self-assembled monolayers (SAMs). The evolution of p-terphenylthiol (TPT) SAMs on Au(111) surfaces into cross-linked monolayers was observed with a scanning tunneling microscope. As the irradiation dose was increased, the cross-linked regions continued to grow and a large number of subnanometer voids appeared. Their equivalent diameter is 0.5 ± 0.2 nm and the areal density is ≈1.7 × 1017 m−2. Supported by classical molecular dynamics simulations, we propose that these voids may correspond to free volumes inside a cross-linked monolayer.