This paper presents the effects of process conditions and nano‐clay fillers on the microstructure (namely, size, density, and distribution of microcells within samples) and the resulting mechanical properties of microcellular injection molded polyamide‐6 (PA‐6) nanocomposite and its neat‐resin counterpart. Based on the design of experiments (DOE) matrices, samples were molded at various supercritical fluid (SCF) levels, melt temperatures, shot sizes, melt plastication pressures (MPP), and injection speeds. These samples were then subjected to scanning electron microscope (SEM) analysis, tensile testing, and impact testing. For both materials, the microstructure and the mechanical properties of the molded samples were found to be dependent on the process conditions and presence of nano‐clay, which could serve as microcell nucleating agent. At higher weight reductions, the nanocomposite samples exhibit much smaller microcells and higher cell densities than those obtained in the neat‐resin samples. The SEM micrographs reveal noticeable differences in microcell surface roughness between the nanocomposite and the neat resin. A statistical design analysis was used to identify the optimal process conditions that would result in desirable cell size and density and, thus, better mechanical properties. For example, the highest tensile strengths have been observed at the highest levels of shot size, MPP, injection speed, and SCF level, and at the lowest level of melt temperature.

No abstract