Chemolithoautotrophic denitrifying microorganisms oxidize reduced inorganic sulfur compounds coupled to the reduction of nitrate as an electron acceptor. These denitrifiers can be applied to the removal of nitrogen and/or sulfur contamination from wastewater, groundwater, and gaseous streams. This study investigated the physiology and kinetics of chemolithotrophic denitrification by an enrichment culture utilizing hydrogen sulfide, elemental sulfur, or thiosulfate as electron donor. Complete oxidation of sulfide to sulfate was observed when nitrate was supplemented at concentrations equal or exceeding the stoichiometric requirement. In contrast, sulfide was only partially oxidized to elemental sulfur when nitrate concentrations were limiting. Sulfide was found to inhibit chemolithotrophic sulfoxidation, decreasing rates by approximately 21-fold when the sulfide concentration increased from 2.5 to 10.0 mM, respectively. Addition of low levels of acetate (0.5 mM) enhanced denitrification and sulfate formation, suggesting that acetate was utilized as a carbon source by chemolithotrophic denitrifiers. The results of this study indicate the potential of chemolithotrophic denitrification for the removal of hydrogen sulfide. The sulfide/nitrate ratio can be used to control the fate of sulfide oxidation to either elemental sulfur or sulfate.

This study investigated removal of sulfide and p-cresol linked to denitrification in laboratory-scale upflow anaerobic granular sludge bed (UASB) bioreactors. Three parallel denitrification bioreactors were run for nine months, which were operated under chemolithoautotrophic conditions (i.e., using sulfide as electron donor -e-donor- and bicarbonate as C source); heterotrophic conditions (with p-cresol as e-donor and C source), and mixotrophic conditions (utilizing both sulfide and p-cresol as electron donors), respectively. The average hydraulic retention time and nitrate load applied to the bioreactors was 13.4 h and 1,240 mg N-NO3/l/day, respectively. The nitrate removal efficiency was 89, 95 and 99%, respectively, for the chemo-, hetero- and mixotrophic reactors. The mixotrophic UASB removed both sulfide and p-cresol almost completely, indicating that simultaneous removal of the inorganic and organic e-donors occurred. Nitrite was seldom observed as an intermediate. N2O gas and methane concentrations in the biogas were also negligible. These results indicate that mixotrophic denitrification with phenols and sulfide is feasible in high rate UASB reactors.

In this study, the anoxic oxidation of arsenite (As(III)) linked to chemolithotrophic denitrification was shown to be feasible in continuous bioreactors. Biological oxidation of As(III) was stable over prolonged periods of operation ranging up to 3 years in continuous denitrifying bioreactors with granular biofilms. As(III) was removed with a high conversion efficiency (> 92%) to arsenate (As(V)) in periods with high volumetric loadings (e.g. 3.5 to 5.1 mmol As Lreactor−1 d−1). The maximum specific activity of sampled granular sludge from the bioreactors was 0.98±0.04 mmol As(V) formed g−1 VSS d−1 when determined at an initial concentration of 0.5 mM As(III). The microbial population adapted to high influent concentrations of As(III) up to 5.2 mM. However, the As(III) oxidation process was severely inhibited when 7.6 to 8.1 mM As(III) was fed. Activity was restored upon lowering the As(III) concentration to 3.8 mM. Several experimental strategies were utilized to demonstrate a dependence of the nitrate removal on As(III) oxidation as well as a dependence of the As(III) removal on nitrate reduction. The molar stoichiometric ratio of As(V) formed to nitrate removed (corrected for endogenous denitrification) in the bioreactors approximated 2.5, indicating complete denitrification was occurring. As(III) oxidation was also shown to be linked to the complete denitrification of NO3− to N2 gas by demonstrating a significantly enhanced production of N2 beyond the background endogenous production in a batch bioassay spiked with 3.5 mM As(III). The N2 production also corresponded closely to the expected stoichiometry of 2.5 mol As(III) mol−1 N2-N for complete denitrification.