Solar energy is readily available in most climates and can be used for water purification. However, solar disinfection of drinking water mostly relies on ultraviolet light, which represents only 4% of the total solar energy, and this leads to a slow treatment speed. Therefore, the development of new materials that can harvest visible light for water disinfection, and so speed up solar water purification, is highly desirable. Here we show that few-layered vertically aligned MoS (FLV-MoS) films can be used to harvest the whole spectrum of visible light (∼50% of solar energy) and achieve highly efficient water disinfection. The bandgap of MoS was increased from 1.3 to 1.55 eV by decreasing the domain size, which allowed the FLV-MoS to generate reactive oxygen species (ROS) for bacterial inactivation in the water. The FLV-MoS showed a ∼15 times better log inactivation efficiency of the indicator bacteria compared with that of bulk MoS, and a much faster inactivation of bacteria under both visible light and sunlight illumination compared with the widely used TiO. Moreover, by using a 5 nm copper film on top of the FLV-MoS as a catalyst to facilitate electron-hole pair separation and promote the generation of ROS, the disinfection rate was increased a further sixfold. With our approach, we achieved water disinfection of >99.999% inactivation of bacteria in 20 min with a small amount of material (1.6 mg l) under simulated visible light.

Outdoor heat stress poses a serious public health threat and curtails industrial labor supply and productivity, thus adversely impacting the wellness and economy of the entire society. With climate change, there will be more intense and frequent heat waves that further present a grand challenge for sustainability. However, an efficient and economical method that can provide localized outdoor cooling of the human body without intensive energy input is lacking. Here, a novel spectrally selective nanocomposite textile for radiative outdoor cooling using zinc oxide nanoparticle-embedded polyethylene is demonstrated. By reflecting more than 90% solar irradiance and selectively transmitting out human body thermal radiation, this textile can enable simulated skin to avoid overheating by 5-13 °C compared to normal textile like cotton under peak daylight condition. Owing to its superior passive cooling capability and compatibility with large-scale production, this radiative outdoor cooling textile is promising to widely benefit the sustainability of society in many aspects spanning from health to economy.

No abstract

Space heating accounts for the largest energy end-use of buildings that imposes significant burden on the society. The energy wasted for heating the empty space of the entire building can be saved by passively heating the immediate environment around the human body. Here, we demonstrate a nanophotonic structure textile with tailored infrared (IR) property for passive personal heating using nanoporous metallized polyethylene. By constructing an IR-reflective layer on an IR-transparent layer with embedded nanopores, the nanoporous metallized polyethylene textile achieves a minimal IR emissivity (10.1%) on the outer surface that effectively suppresses heat radiation loss without sacrificing wearing comfort. This enables 7.1 °C decrease of the set-point compared to normal textile, greatly outperforming other radiative heating textiles by more than 3 °C. This large set-point expansion can save more than 35% of building heating energy in a cost-effective way, and ultimately contribute to the relief of global energy and climate issues.

No abstract