A technique of measuring contact resistance between an individual nanotube and a deposited metallic film is described. Using laser ablation to sequentially shorten the contact length between a nanotube and the evaporated metallic film, the linear resistivity of the nanotube as well as the specific contact resistivity between the nanotube and metallic film can be determined. This technique can be generally used to measure the specific contact resistance that develops between a metallic film and a variety of different nanowires and nanotubes.

The design, fabrication, and characterization of a novel low-frequency meandering piezoelectric vibration energy harvester is presented. The energy harvester is designed for sensor node applications where the node targets a width-to-length aspect ratio close to 1:1 while simultaneously achieving a low resonant frequency. The measured power output and normalized power density are 118 μW and 5.02 μW/mm(3)/g(2), respectively, when excited by an acceleration magnitude of 0.2 g at 49.7 Hz. The energy harvester consists of a laser-machined meandering PZT bimorph. Two methods, strain-matched electrode (SME) and strain-matched polarization (SMP), are utilized to mitigate the voltage cancellation caused by having both positive and negative strains in the piezoelectric layer during operation at the meander's first resonant frequency. We have performed finite element analysis and experimentally demonstrated a prototype harvester with a footprint of 27 x 23 mm and a height of 6.5 mm including the tip mass. The device achieves a low resonant frequency while maintaining a form factor suitable for sensor node applications. The meandering design enables energy harvesters to harvest energy from vibration sources with frequencies less than 100 Hz within a compact footprint.

In this letter, volume Fresnel zone plates fabricated inside fused silica using femtosecond laser direct writing are demonstrated. A volume zone plate consists of a number of layers of Fresnel zone plates designed to focus light together. Results indicate that volume Fresnel zone plates increase the overall diffraction efficiency significantly. Phase zone plates yield considerably higher diffraction efficiency due to a number of reasons including negligible light absorption, robustness against fabrication phase errors, and minimum interference between different zone plates in a volume.

This letter describes a bowtie nanoaperture antenna for coupling light to a subdiffraction limited near-field spot ͑Ͻ / 8͒. The gain of the antenna is increased using a concentric grating structure to coherently diffract normally incident light toward the aperture. We experimentally demonstrate that the addition of the grating structure enhances the far-field transmission through the aperture by 6.9 times while the intensity at the near-field is increased more than 15 times. The nanoantenna is useful for applications including nanolithography and data storage.

No abstract