Objectives:To investigate the effect of the addition of glass flakes on physical properties of conventional heat cure denture base resins and to compare it with a high impact strength denture base resin.Materials and Methods:Test specimens were divided into Group 1 - poly (methyl methacrylate) (PMMA) (Trevalon), Group 2 - Trevalon HI, Group 3 -5% glass flake +95% PMMA (Trevalon), Group 4 -10% glass flake +90% PMMA (Trevalon), and Group 5 -20% glass flake +80% PMMA (Trevalon). For glass flake modified groups, part of PMMA (powder) was substituted with the same weight of glass flake (GF003 m) as required, to bring it to 100% powder. Flexural strength was tested using three-point bending test and impact strength with Izod type impact tester.Results:Plain PMMA (Trevalon), showed the highest value of flexural strength followed by Trevalon HI. Trevalon HI (highly cross-linked PMMA) group showed the highest value of impact strength.Conclusion:Flexural strength of unmodified PMMA denture base resin decreases with increase in the concentration of glass flakes. Impact strength does not show any significant change at 5% concentration of glass flakes and impact strength significantly reduces with the addition of glass flakes in 10% and 20%.

Implant surgery in mandibular anterior region may turn from an easy minor surgery into a complicated one for the surgeon, due to inadequate knowledge of the anatomy of the surgical area and/or ignorance toward the required surgical protocol. Hence, the purpose of this article is to present an overview on the: (a) Incidence of massive bleeding and its consequences after implant placement in mandibular anterior region. (b) Its etiology, the precautionary measures to be taken to avoid such an incidence in clinical practice and management of such a hemorrhage if at all happens. An inclusion criterion for selection of article was defined, and an electronic Medline search through different database using different keywords and manual search in journals and books was executed. Relevant articles were selected based upon inclusion criteria to form the valid protocols for implant surgery in the anterior mandible. Further, from the selected articles, 21 articles describing case reports were summarized separately in a table to alert the dental surgeons about the morbidity they could come across while operating in this region. If all the required adequate measures for diagnosis and treatment planning are taken and appropriate surgical protocol is followed, mandibular anterior region is no doubt a preferable area for implant placement.

Maxillofacial defects may be due to congenital defect, trauma, tumor or infection. Among infections, fungal head and neck infections are common complication in patients with immunological or metabolic compromise. Cerebral extension of these infections often complicates the treatment plan. Treating these cases requires correction of the compromised state, local and systemic anti-fungal therapy and repeated radical debridement assisted by serial imaging. Following debridement, the resultant deformity can be corrected either surgically or prosthetically. Many factors are to be considered regarding the choice of the treatment. Here is a case report of a 55 year old male diabetic patient with oro-nasal mycosis, where debridement resulted in a gross morbid defect of the dorsum of the nose and the hard palate. Prosthetic rehabilitation was carried out with separate nasal prosthesis and a palatal feeding obturator.

No abstract