Simple single-dopant white organic light-emitting devices (WOLEDs) with optimized efficiency/color quality/brightness trade-offs are developed; the white light produced shows the best color quality ever exhibited by WOLEDs at very high brightness, and is even able to duplicate the natural sunlight source.

Efficient crystalline silicon heterojunction solar cells are fabricated on p-type wafers using amorphous silicon emitter and back contact layers. The independently confirmed AM1.5 conversion efficiencies are 19.3% on a float-zone wafer and 18.8% on a Czochralski wafer; conversion efficiencies show no significant light-induced degradation. The best open-circuit voltage is above 700 mV. Surface cleaning and passivation play important roles in heterojunction solar cell performance.

Films were prepared by hot wire chemical vapor deposition at ∼240 °C with varied hydrogen dilution ratios R=H2:SiH4 from 1 to 20. The optical and electronic properties as a function of microcrystallinity were studied. We found: (a) At low H dilution R⩽2, there is no measurable crystallinity by Raman spectroscopy and x-ray diffraction in the a-Si:H matrix, but an optical absorption peak at ∼1.25 eV appears; when R=2, the film shows the lowest subgap absorption, the highest photosensitivity, and the largest optical gap. (b) When R⩾3, the c-Si phase is measurable by Raman and a low-energy photoluminescence (PL) band (0.84–1.0 eV) appears in addition to the high-energy band (1.3–1.4 eV). Meanwhile, all the absorption spectra show a featureless line shape. (c) An energy redshift is observed for both PL peaks as the film grows thicker. Finally, (d) the conductivity activation energy first decreases from 0.68 to 0.12 eV, then increases with increasing microcrystallinity. A mode of two sets of energy bands of electronic states for these two-phase materials is suggested.

The morphology optimization strategies and great potentials in constructing stable and large-area organic solar cells via sequential deposition are discussed.