Recently, graphene-based semiconductor photocatalysts have attracted more attention because of their enhanced photocatalytic activity caused by interfacial charge transfer (IFCT). However, the effect of a chemical bond is rarely involved for the IFCT. In this work, TiO2/graphene composites with a chemically bonded interface were prepared by a facile solvothermal method using tetrabutyl orthotitanate (TBOT) as the Ti source. The chemically bonded TiO2/graphene composites effectively enhanced their photocatalytic activity in photodegradation of formaldehyde in air, and the graphene content exhibited an obvious influence on the photocatalytic activity. The prepared composite with 2.5 wt % graphene (G2.5-TiO2) showed the highest photocatalytic activity, exceeding that of Degussa P25, as-prepared pure TiO2 nanoparticles, and the mechanically mixed TiO2/graphene (2.5 wt %) composite by a factor of 1.5, 2.6, and 2.3, respectively. The enhancement in the photocatalytic activity was attributed to the synergetic effect between graphene and TiO2 nanoparticles. Other than the graphene as an excellent electron acceptor and transporter, the enhanced photocatalytic activity was caused by IFCT through a C–Ti bond, which markedly decreased the recombination of electron–hole pairs and increased the number of holes participating in the photooxidation process, confirmed by XPS analysis, the gaseous phase transient photocurrent response, electrochemical impedance spectroscopy, and photoluminescence spectra. This work about effective IFCT through a chemically bonded interface can provide new insights for directing the design of new heterogeneous photocatalysts, which can be applied in environmental protection, water splitting, and photoelectrochemical conversion.

Novel zinc oxide quantum dots (ZnO QDs) decorated graphene nanocomposites were fabricated by a facile solution-processed method. ZnO QDs with a size ca. 5 nm are nucleated and grown on the surface of the graphene template, and its distribution density can be easily controlled by the reaction time and precursor concentration. The ZnO QDs/graphene nanocomposite materials enhance formaldehyde sensing properties by 4 times compared to pure graphene at room temperature. Moreover, the sensors based on the nanocomposites have fast response (ca. 30 seconds) and recovery (ca. 40 seconds) behavior, excellent room temperature selectivity and stability. The gas sensing enhancement is attributed to the synergistic effect of graphene and ZnO QDs. The electron transfer between the ZnO QDs and the graphene is due to oxidation process of the analyzed gas on the ZnO QDs' surface. This proposed gas sensing mechanism is experimentally proved by DRIFT spectra results. The ZnO QDs/graphene nanocomposites sensors have potential applications for monitoring air pollution, especially for harmful and toxic VOCs (volatile organic compounds).

To improve the gas-sensing performance of metal-oxide-semiconductors, the effect of defects on gas-sensing properties has been widely investigated. Nevertheless, although the metal cation defect is the dominative acceptor defect in p-type semiconductors, its effect on the gas-sensing properties remains blank, which leads to a hindrance for further developing p-type semiconductor-based gas sensors. Accordingly, to eleborate the effect of metal cation defects on the sensing properties, mesoporous NiO nanosheets with different amounts of nickel vacancies were prepared by annealing at different temperatures. It was found that the amount of nickel vacancies increased with increasing the annealing temperature. Gas-sensing studies revealed that the NiO with a higher concentration of nickel vacancies exhibited higher sensitivity to NO2 at room temperature. With further increasing the annealing temperature to 600 °C, although the rapid decrease in the specific surface area of the NiO might limit the physisorption of NO2, the NiO could also present a better sensitivity to NO2 due to the abundant nickel vacancies with high activity. Furthermore, an in situ DRIFTS study demonstrated that the number of adsorbed nitrate and nitrite species on NiO surfaces increased with increasing the amount of nickel vacancies, indicating that the nickel vacancies acted as the dominative active sites participating in the gas–solid reaction and then determined the room-temperature sensing properties. According to the defect ionization equation, a hole conduction model was further proposed to decipher the dependency of sensing properties on the metal cation defects. We hope this work could make us better understand the roles of cation defect in the sensing properties, and it could also benefit the improvement of p-type semiconductor-based gas sensors.

After the successful solvothermal synthesis of graphene (GR) from ethanol and sodium, we obtained chemically bonded graphene/BiOCl (GR/BiOCl) nanocomposite photocatalysts via a facile chemical-bath method. A significant enhancement was observed in the photodegradation of methylbenzene, which was largely ascribed to the chemical coupling effects between Bi and C, as shown by X-ray photoelectron spectroscopy. Raman spectroscopy also indicated an increased size of the sp(2) ring clusters and decreased disorder in the graphitic structure, as substitutions of defects like vacancies as well as oxygen containing carbonaceous groups with C-Bi attachment take place. Overall, information about chemical coupling effects between GR and BiOCl might take us a step further in GR-based hybrid materials, providing a very good reference to the fabrication of chemically bonded GR/semiconductor compounds and facilitating their applications in environmental protection, photo-electrochemical conversion and photocatalytic decomposition of water.

The tyrosine kinase domain (TKD) mutations of receptor tyrosine kinase C-KIT are associated with a poor prognosis in acute myeloid leukemia (AML). However, the underlying mechanisms are not fully understood. We found the activity of protein phosphatase 2A (PP2A), a human tumor suppressor whose dysfunction contributes to malignant cell behavior, was significantly decreased in AML subgroups harboring C-KIT/D816V and AML cell line Kasumi-1 bearing C-KIT/N822K mutation. Primary AML cells and various AML cell lines were treated with PP2A activator FTY720. FTY720 showed a toxic effect in all leukemic cells, especially for cells harboring C-KIT/TKD mutation. Furthermore, FTY720-induced toxicity in AML leukemic cells was mediated by restoration of PP2A activity, via down-regulation of PP2A inhibitor SET, dephosporylation of PP2A-C(TYR307), and up-regulation of relevant PP2A subunit A and B55α. Our research indicates that the decreased PP2A activity in AML harboring C-KIT/TKD mutation may make the restoration of PP2A activity a novel therapy for AML patients with C-KIT/TKD mutation.