Researchers have shown great interest in two-dimensional crystals recently, because of their thickness-dependent electronic and optical properties. We have investigated the Raman and photoluminescence spectra of free-standing monolayer and bilayer MoS2, as a function of pressure. As the enforcement of layer interaction, an electronic and a crystal phase transition were revealed at ∼6 GPa and ∼16 GPa, respectively, in bilayer MoS2, while no phase transition in the monolayer is observed. The electronic phase transition at ∼6 GPa is supposed to be a direct interband changing to an indirect Λ-K interband transition, and the new structure shown at ∼16 GPa is not metallized and supposed to be a transformation from stacking faults due to layer sliding like 2Hc to 2Ha. The different pressure-induced features of monolayer MoS2, compared with bilayer MoS2, can help to get a better understanding about the importance of interlayer interaction on modifying the optical properties of MoS2 and other fundamental understanding of 2D materials.
HgTe film is widely used for quantum Hall well studies and devices, as it has unique properties, like band gap inversion, carrier‐type switch, and topological evolution depending on the film thickness modulation near the so‐called critical thickness (63.5 Å), while its counterpart bulk materials do not hold these nontrivial properties at ambient pressure. Here, much richer transport properties emerging in bulk HgTe crystal through pressure‐tuning are reported. Not only the above‐mentioned abnormal properties can be realized in a 400 nm thick bulk HgTe single crystal, but superconductivity is also discovered in a series of high‐pressure phases. Combining crystal structure, electrical transport, and Hall coefficient measurements, a p‐n carrier type switching is observed in the first high‐pressure cinnabar phase. Superconductivity emerges after the semiconductor‐to‐metal transition at 3.9 GPa and persists up to 54 GPa, crossing four high‐pressure phases with an increased upper critical field. Density functional theory calculations confirm that a surface‐dominated topologic band structure contributes these exotic properties under high pressure. This discovery presents broad and efficient tuning effects by pressure on the lattice structure and electronic modulations compared to the thickness‐dependent critical properties in 2D and 3D topologic insulators and semimetals.
Pressure evolution of local structure and vibrational dynamics of the perovskite-type relaxor ferroelectric single crystal of 0.935(Na0.5Bi0.5)TiO3-0.065BaTiO3 (NBT-6.5BT) is systematically investigated via in situ Raman spectroscopy. The pressure dependence of phonon modes up to 30 GPa reveals two characteristic pressures: one is at around 4.6 GPa which corresponds to the rhombohedral-to-tetragonal phase transition, showing that the pressure strongly suppresses the coupling between the off-centered A- and B-site cations; the other structural transition involving the oxygen octahedral tilt and vibration occurs at pressure ∼13–15 GPa with certain degree of order-disorder transition, evidenced by the abnormal changes of intensity and FWHM in Raman spectrum.
The comparison of different stereoisomeric organic compounds under high pressure has been less investigated. Here, we chose different stereochemical configurations of cis/trans-stilbene to study the luminescence properties, polymerization reaction, and structural changes at 0–20 GPa by spectroscopy and XRD. No fluorescence enhancement occurred in cis-stilbene due to π–π stacking. At 16 GPa, the IR, UV–vis, and sample color changes show that it undergoes an irreversible polymerization, that C(sp2)–H changes to C(sp2 + sp3)–H. However, trans-stilbene undergoes fluorescence enhancement at 0–4 GPa due to the reduction of the torsion angle of the benzene ring and the CC bond leading to the formation of rigid planar molecules, which is further confirmed by the IR and XRD results. At 8 GPa, the new peaks in UV–vis and XRD results show the formation of new substances by structural change. However, the structure of trans-stilbene is more stable, which leads to the return to the raw state after releasing the pressure, and a reversible transformation occurs at high pressure. The cis-trans isomerization under high pressure was also briefly investigated by combining heating and laser irradiation. The cis → trans-stilbene transition can only happen under a fixed-range light irradiation, and the trans → cis-stilbene transition could not happen even under irradiation with a 360 nm laser, which may provide a new idea for synthesizing trans isomers with a higher purity.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.