No abstract

No abstract

Wireless sensor networks are limited by the vast majority of goods with limited resources. Power consumption, network longevity, throughput, routing, and network security are only a few of the research issues that have not yet been addressed in sensor networks based on the Internet of Things. Prior to becoming widely deployed, sensor networks built on the Internet of Things must overcome a variety of technological obstacles as well as general and specific hazards. In order to address the aforementioned problems, this research sought to improve rogue node detection, reduce packet latency/packet loss, increase throughput, and lengthen network lifetime. Wireless energy harvesting is suggested in the proposed three-layer cluster-based wireless sensor network routing protocol to extend the energy lifespan of the network. For the purpose of recognising and blacklisting risky sensor node behaviour, a three-tier clustering architecture with an integrated security mechanism is suggested. This clustering approach is cost-based, and the sink node selects the cluster and grid heads based on the cost function’s value. With its seemingly endless potential across a wide range of industries, including intelligent transportation, the Internet of Things (IoT) has gained prominence recently. To analyse the nodes and clustering strategies in IoT, the suggested method PSO is applied. A plethora of new services, programmes, electrical devices with integrated sensors, and protocols have been produced as a result of the Internet of Things’ explosive growth in popularity.

This research study attempts to create an optimized parametric window by employing Taguchi algorithm for Plasma Arc Welding (PAW) of 2 mm thick 2205 duplex stainless steel. The parameters considered for experimentation and optimization are the welding current, welding speed and pilot arc length respectively. The experimentation involves the parameters variation and subsequently recording the depth of penetration and bead width. Welding current of 60–70 A, welding speed of 250–300 mm/min and pilot arc length of 1–2 mm are the range between which the parameters are varied. Design of experiments is used for the experimental trials. Back propagation neural network, Genetic algorithm and Taguchi techniques are used for predicting the bead width, depth of penetration and validated with experimentally achieved results which were in good agreement. Additionally, micro-structural characterizations are carried out to examine the weld quality. The extrapolation of these optimized parametric values yield enhanced weld strength with cost and time reduction.

Internet of Things (IoT) systems tends to produce massive and diverse kinds of data which needs to be processes and responds in a smallperiod. A most important challenge exists in IoT devices is the amount of energy utilization while transmitting data into cloud. This paper presents a new energy efficient compressive technique with predictive model for IoT based medical data collection and transmission. The proposed model make use of Sensor-Lempel Ziv Welch (SLZW) technique is utilized to perform compressive sensing earlier to data transmission followed by particle swarm optimization (PSO) based deep neural network (DNN) based prediction. The PSO algorithm is applied for optimizing the node count of hidden layer in DNN due to the issue that the classical DNN got trapped into local minima and the node count in hidden layer have to select manually. The performance of the presented SLZW-PSO-DNN algorithm has been validated and the results are investigated under distinct scenarios. The obtained experimental outcome indicated that the SLZW-PSO-DNN algorithm is found to be effective under several aspects over the existing method. The experimental results stated that the PSO-DNN model has resulted in a maximum predictive average accuracy of 98.5% and 98.4% under original and compressed data respectively.