The 4-year results of a fissure sealant trial are reported. Glass polyalkenoate and bis GMA sealant were applied to 590 first permanent molar teeth using a half mouth study design in a group of 228 6-8-year-old children. Similar cariostasis was observed for the two materials at the end of 4 years despite marked differences in retention. Polyalkenoate cements probably should be regarded as 'fluoride depot' materials rather than fissure sealants when used in this context.

Radon movement through 12 test slabs with different cracks, pipe penetrations, cold joints, masonry blocks, sealants, and tensile stresses characterized the importance of these anomalous structural domains. Diffusive and advective radon transport were measured with steady-state air pressure differences controlled throughout the deltaP = 0 to 60 Pa range. Diffusion coefficients (deltaP = 0) initially averaged 6.5 x 10(-8) m2 s(-1) among nine slabs with only 8% standard deviation, but increased due to drying by 0.16% per day over a 2-y period to an average of 2.0 x 10(-7) m2 s(-1). An asphalt coating reduced diffusion sixfold but an acrylic surface sealant had no effect. Diffusion was 42 times higher in solid masonry blocks than in concrete and was not affected by small cracks. Advective transport (deltaP < or = 60 Pa) was negligible for the slabs (10(-16) m2 permeability), pipe penetrations, and caulked gaps, but was significant for cracks, disturbed pipe penetrations, cold joints, masonry blocks, and concrete under tensile stress. Crack areas calculated to be as small as 10(-7) m2 significantly increased radon advection. Algebraic expressions predict air velocity and effective crack width from enhanced radon transport and air pressures. Masonry blocks, open cracks, and slab cold joints enhance radon penetration but stressed slabs, undisturbed pipe penetrations, and sealed cracks may not.