The Mars Global Surveyor (MGS) z -axis accelerometer has obtained over 200 vertical structures of thermospheric density, temperature, and pressure, ranging from 110 to 170 kilometers, compared to only three previous such vertical structures. In November 1997, a regional dust storm in the Southern Hemisphere triggered an unexpectedly large thermospheric response at mid-northern latitudes, increasing the altitude of thermospheric pressure surfaces there by as much as 8 kilometers and indicating a strong global thermospheric response to a regional dust storm. Throughout the MGS mission, thermospheric density bulges have been detected on opposite sides of the planet near 90°E and 90°W, in the vicinity of maximum terrain heights. This wave 2 pattern may be caused by topographically-forced planetary waves propagating up from the lower atmosphere.

No abstract

[1] We have used density measurements obtained during aerobraking (AB) on Mars Global Surveyor and Mars Odyssey to examine mean densities and the characteristics and variability of gravity waves (GWs) in the upper atmosphere of Mars. Mean densities exhibit variability with latitude and season and in response to variable forcing and filtering from below. These data also reveal significant variability of GWs, both spatially and temporally. In general, GW amplitudes increase, while apparent horizontal scales remain the same, with increasing altitude. The dominant spatial scales at the lower AB altitudes are typically $20-200 km and density fluctuations vary from $5 to 50%, though even larger values are occasionally observed. GW amplitudes also vary significantly with season, being generally larger in winter and at middle and high latitudes, and apparently reflecting mean source and filtering conditions. Amplitudes also appear to vary with longitude and time and may provide clues to variability of, and interactions with, largerscale motions.

The Mars Atmosphere and Volatile Evolution (MAVEN) mission, during the second of its Deep Dip campaigns, made comprehensive measurements of martian thermosphere and ionosphere composition, structure, and variability at altitudes down to ~130 kilometers in the subsolar region. This altitude range contains the diffusively separated upper atmosphere just above the well-mixed atmosphere, the layer of peak extreme ultraviolet heating and primary reservoir for atmospheric escape. In situ measurements of the upper atmosphere reveal previously unmeasured populations of neutral and charged particles, the homopause altitude at approximately 130 kilometers, and an unexpected level of variability both on an orbit-to-orbit basis and within individual orbits. These observations help constrain volatile escape processes controlled by thermosphere and ionosphere structure and variability.

Aerobraking was an enabling technology for the Mars Odyssey mission even though it involved risk due primarily to the variability of the Mars upper atmosphere. Consequently, numerous analyses based on various data types were performed during operations to reduce these risk and among these data were measurements from spacecraft accelerometers. This paper reports on the use of accelerometer data for determining atmospheric density duringOdyssey aerobraking operations. Acceleration was measured along three orthogonal axes, although only data from the component along the axis nominally into the flow was used during operations. For a one second count time, the RMS noise level varied from 0.07 to 0.5 mm/s 2 permitting density recovery to between 0.15 and 1