Large particles containing nitric acid (HNO3) were observed in the 1999/2000 Arctic winter stratosphere. These in situ observations were made over a large altitude range (16 to 21 kilometers) and horizontal extent (1800 kilometers) on several airborne sampling flights during a period of several weeks. With diameters of 10 to 20 micrometers, these sedimenting particles have significant potential to denitrify the lower stratosphere. A microphysical model of nitric acid trihydrate particles is able to simulate the growth and sedimentation of these large sizes in the lower stratosphere, but the nucleation process is not yet known. Accurate modeling of the formation of these large particles is essential for understanding Arctic denitrification and predicting future Arctic ozone abundances.

[1] In situ measurements of the mass, mixing state, and optical size of individual black-carbon (BC) particles in the fine mode (90 -600 nm) have been made in fresh emissions from urban and biomass burning sources with an airborne single-particle soot photometer. Contrasts between the two sources are significant and consistent. Urban BC tends to smaller sizes, fewer coated particles, thinner coatings, and less absorption per unit mass than biomass-burning BC. This suggests that urban BC may have a longer lifetime in the atmosphere and a different impact on BC radiative forcing in the first indirect effect than biomass-burning BC. These measurements bound the likely variability in the microphysical state of BC emissions from typical continental processes, and provide direct measurements of the size distribution and coating state of fine-mode BC for use in constraining climate and aerosol models. These results highlight the need for the integration of sourcespecific information into such models. Citation: Schwarz, J. P., et al. (2008), Measurement of the mixing state, mass, and optical size of individual black carbon particles in urban and biomass burning emissions, Geophys. Res. Lett., 35, L13810,

[1] Black carbon (BC) is the dominant aerosol absorber of solar radiation in the atmosphere and is an important component of anthropogenic climate forcing. BC's role is strongly dependent on its physical state, which can influence the way that BC particles may act as ice and cloud nuclei, as well as the way they interact with solar radiation. In situ measurements made with a single-particle soot photometer flown on a NASA high-altitude research aircraft show the mass and size of individual BC particles in the tropics, as well as their propensity to be found mixed with additional materials. Mie theory was used to connect observed light scattering off BC particles to the optical effects of coatings on the particles. The observations indicate that as BC from ground-based emission sources rises in altitude to the lower stratosphere, coatings on BC particles become both thicker and more prevalent, while BC mass mixing ratios decrease dramatically from their values near the ground. Coatings enhance light absorption by the ambient BC column by at least 30%. These results reveal the microphysical state of BC in the atmosphere while providing important constraints for models evaluating BC's role in climate change.

A Single-Particle Soot Photometer (SP2) detects black refractory or elemental carbon (EC) in particles by passing them through an intense laser beam. The laser light heats EC in particles causing them to vaporize in the beam. Detection of wavelength-resolved thermal radiation emissions provides quantitative information on the EC mass of individual particles in the size range of 0.2-1 μm diameter. Non-absorbing particles are sized based on the amount of light they scatter from the laser beam. The time series of the scattering signal of a non-absorbing particle is a Gaussian, because the SP2 laser is in the TEM00 mode. Information on the scattering properties of externally and internally mixed EC particles as detected by the SP2 is lost in general, because each particle changes size, shape, and composition as it passes through the laser beam. Thus, scattered light from a sampled EC particle does not yield a full Gaussian waveform. A method for determining the scattering properties of EC particles using a two-element avalanche photodiode (APD) is described here. In this method, the Gaussian scattering function is constructed from the leading edge of the scattering signal (before the particle is perturbed by the laser), the Gaussian width, and the location of the leading edge in the beam derived from the two-element APD signal. The method allows an SP2 to determine the scattering properties of individual EC particles as well as the EC mass. Detection of polystyrene latex spheres, wellcharacterized EC particles with and without organic coatings, and Mie scattering calculations are used to validate the method.