Vibrational spectroscopies using infrared radiation, Raman scattering, neutrons, low-energy electrons and inelastic electron tunnelling are powerful techniques that can analyse bonding arrangements, identify chemical compounds and probe many other important properties of materials. The spatial resolution of these spectroscopies is typically one micrometre or more, although it can reach a few tens of nanometres or even a few ångströms when enhanced by the presence of a sharp metallic tip. If vibrational spectroscopy could be combined with the spatial resolution and flexibility of the transmission electron microscope, it would open up the study of vibrational modes in many different types of nanostructures. Unfortunately, the energy resolution of electron energy loss spectroscopy performed in the electron microscope has until now been too poor to allow such a combination. Recent developments that have improved the attainable energy resolution of electron energy loss spectroscopy in a scanning transmission electron microscope to around ten millielectronvolts now allow vibrational spectroscopy to be carried out in the electron microscope. Here we describe the innovations responsible for the progress, and present examples of applications in inorganic and organic materials, including the detection of hydrogen. We also demonstrate that the vibrational signal has both high- and low-spatial-resolution components, that the first component can be used to map vibrational features at nanometre-level resolution, and that the second component can be used for analysis carried out with the beam positioned just outside the sample--that is, for 'aloof' spectroscopy that largely avoids radiation damage.

CO2 sequestration via carbonation of widely available low-cost minerals, such as olivine, can permanently dispose of CO2 in an environmentally benign and a geologically stable form. We report the results of studies of the mechanisms that limit aqueous olivine carbonation reactivity under the optimum sequestration reaction conditions observed to date: 1 M NaCl + 0.64 M NaHCO3 at Te 185 degrees C and P(CO2) approximately equal to 135 bar. A reaction limiting silica-rich passivating layer (PL) forms on the feedstock grains, slowing carbonate formation and raising process cost. The morphology and composition of the passivating layers are investigated using scanning and transmission electron microscopy and atomic level modeling. Postreaction analysis of feedstock particles, recovered from stirred autoclave experiments at 1500 rpm, provides unequivocal evidence of local mechanical removal (chipping) of PL material, suggesting particle abrasion. This is corroborated by our observation that carbonation increases dramatically with solid particle concentration in stirred experiments. Multiphase hydrodynamic calculations are combined with experimentto better understand the associated slurry-flow effects. Large-scale atomic-level simulations of the reaction zone suggest that the PL possesses a "glassy" but highly defective SiO2 structure that can permit diffusion of key reactants. Mitigating passivating layer effectiveness is critical to enhancing carbonation and lowering sequestration process cost.

No abstract

Lamellar dehydroxylation mechanisms are important in understanding highly reactive nanocrystal oxide formation as well as a variety of applied lamellar hydroxide reaction processes. These mechanisms have been observed for the first time via in situ nanoscale imaging for the prototype lamellar hydroxide: Mg(OH) 2 . Environmental-cell, dynamic highresolution transmission electron microscopy was combined with advanced computational modeling in discovering that lamellar nucleation and growth processes govern dehydroxylation. The host lamella can guide the formation of a solid solution series of lamellar oxyhydroxide intermediates en route to oxide formation. This investigation opens the door to a deeper, atomic-level understanding of lamellar dehydroxylation reaction processes, nanocrystal oxide formation, and the range of potential new intermediate materials and third component reaction pathways they can provide.

The origins and the recent accomplishments of aberration correction in scanning transmission electron microscopy (STEM) are reviewed. It is remembered that the successful correction of imaging aberrations of round lenses owes much to the successful correction of spectrum aberrations achieved in electron energy loss spectrometers 2-3 decades earlier. Two noteworthy examples of the types of STEM investigation that aberration correction has made possible are shown: imaging of single-atom impurities in graphene and analyzing atomic bonding of single atoms by electron energy loss spectroscopy (EELS). Looking towards the future, a new all-magnetic monochromator is described. The monochromator uses several of the principles pioneered in round lens aberration correction, and it employs stabilization schemes that make it immune to variations in the high voltage of the microscope and in the monochromator main prism current. Tests of the monochromator carried out at 60 keV have demonstrated energy resolution as good as 12 meV and monochromated probe size of ∼1.2 Å. These results were obtained in separate experiments, but they indicate that the instrument can perform imaging and EELS with an atom-sized probe <30 meV wide in energy, and that an improvement in energy resolution to 10 meV and beyond should be possible in the future.