No abstract

Real cylinder bores are out-of-round and axially asymmetrical. The top compression ring, nominally an incomplete circle, is subjected to ring tension and cyclic combustion force in order to conform to the bore surface. The bounding surfaces are rough and their conjunction is subject to a transient tribological state. Therefore, the ring-bore conjunction is only partially conforming for most of the engine cycle. The conjunction may be viewed as a problem of scale, depending on the analysis carried out at a certain bore order (out-of-roundness). Therefore, the contact may be viewed as a multi-lobed rough conjunction, where the regime of lubrication may vary from hydrodynamics to mix with dominant asperity friction at piston reversals. Measured bores and ring profiles are used to predict conjunctional power loss and percentage fuel energy consumed. Furthermore, lubricant's flow through the ring is predicted throughout the engine cycle. These measures are key industrial design drivers for fuel efficiency and reduction of emissions. The results show that the effect of bore out-of-roundness can be even more significant than the surface topography.

No abstract

The piston ring/cylinder liner conjunction can experience various regimes of lubrication during piston strokes inside the engine cylinder. In the current engines, the nature of lubrication usually remains hydrodynamic at mid-stroke whilst a mixed regime of lubrication may be experienced at and near reversals. The direct contact between the tips of some of the asperities of opposing surfaces leads to mixed (partial) regime of lubrication. A model proposed by Greenwood and Tripp can be used to predict asperity level contribution to the total piston friction. At the same time Reynolds equation can be employed to predict the portion of load carried by the lubricant trapped between the asperities. Friction between the asperity tips is usually proportional to the load that they support; stated in terms of a proportionality factor; i.e. coefficient of friction. The surfaces are usually furnished with hard wear resistant coatings and in parts by solid lubricants. Both the piston rings and cylinder liner surfaces are usually coated. These coatings change the friction characteristics of the counterfaces because of their surface topography as well as material mechanical properties. AFM is used to obtain surface topographical parameters in contact tapping mode. The corresponding surface topographical parameters are obtained from representative regional areas of the contacting solid surfaces, using a Talysurf. The combination of topography and coating characteristics are used to develop the necessary parameters for a boundary friction model. A numerical model of the top compression ring to cylinder liner is developed based on mixed-hydrodynamic regime of lubrication. The results for friction and the effect of coating on the power loss and wear of the conjunction are discussed in the paper.

Reciprocating and low-speed sliding contacts can experience increased friction because of solid boundary interactions. Use of surface texturing has been shown to mitigate undue boundary friction and improve energy efficiency. A combined numerical and experimental investigation is presented to ascertain the beneficial effect of pressure perturbation caused by micro-hydrodynamics of entrapped reservoirs of lubricant in cavities of textured forms as well as improved microwedge flow. The results show good agreement between numerical predictions and experimental measurements using a precision sliding rig with a floating bed-plate. Results show that the texture pattern and distribution can be optimised for given conditions, dependent on the intended application under laboratory conditions. The translation of the same into practical in-field applications must be carried out in conjunction with the cost of fabrication and perceived economic gain. This means that near optimal conditions may suffice for most application areas and in practice lesser benefits may accrue than that obtained under ideal laboratory conditions.