The aim of this study was to assess the effect of rubber seed kernel heat processing on in vitro rumen biohydrogenation of fatty acids and fermentation. The experiment was conducted with a completely randomized design (CRD). The inclusion of RSK at 0% (CON) and 20% with different processing methods as follows: Raw rubber seed kernel (RAWR), roasted rubber seed kernel (ROR), microwave irradiated rubber seed kernel (MIR), and rubber seed kernel were heated in a hot air oven (RHO) in total mixed ration (TMR) diets. The hydrogen cyanide (HCN) was reduced using RSK heat methods. The heat processing of RSK had no effect on cumulative gas production at 96 h, the gas production from the insoluble fraction (b), or degradability (p > 0.05), whereas it reduced the gas production from the immediately soluble fraction (a) and constant rate of gas production for the insoluble fraction (c) (p < 0.01). The RSK processing methods did not influence ruminal pH, total volatile fatty acid (VFA), or VFA proportions (p > 0.05). RSK heat processing reduced ammonia-nitrogen (NH3-N) (p < 0.04) while increasing the bacterial population (p < 0.02). Heat treatment had no effect on linoleic acid (C18:2 cis-9,12 + tran-9,12) (p > 0.05). The RHO increases oleic acid (C18:1 cis-9 + tran-9) and linolenic acid (C18:3 cis-9,12,15) concentrations (p < 0.01). In conclusion, RHO reduced rumen biohydrogenation of unsaturated fatty acids (UFA), especially C18:3 and C18:1.

Cyanide is a strong toxin in many tropical forage plants that can negatively affect ruminants. The aim of this study is to determine the cyanide removal efficiency, silage quality, and in vitro rumen fermentation of fresh cassava roots ensiled without an additive (control) and with Acremonium cellulase (AC), two cyanide-utilizing bacterial inoculants (Enterococcus feacium KKU-BF7 (BF7) and E. gallinarum KKU-BC10 (BC10)), and their combinations (BF7 + BC10, AC + BF7, AC + BC10 and AC + BF7 + BC10). A completely randomized design was used with eight treatments × four small-scale silo replicates. Additionally, extra silage samples (seven silos/treatment for individually opening after 0, 1, 3, 5, 7, 15, and 30 days of ensiling) were added to observe the changes in the total cyanide concentration and pH value. The fresh cassava root contained an optimal number of lactic acid bacteria (105 colony forming units/g fresh matter), and the contents of dry matter (DM) and total cyanides were 30.1% and 1304 mg/kg DM, respectively. After 30 days of ensiling, all silages demonstrated a low pH (<3.95; p < 0.01). Cyanide content ranged from 638 to 790 mg/kg DM and was highest in the control (p < 0.01). The addition of BF7 + BC10 increased the crude protein (CP) content (p < 0.01). The addition of AC decreased the fibrous contents (p < 0.01). The control had less acetic acid and propionic acid contents (p < 0.01) and a greater butyric acid content (p < 0.01). However, the degrees of in vitro DM digestibility (IVDMD) and gas production were similar among treatments. Methane production ranged between 29.2 and 33.3 L/kg IVDMD (p < 0.05), which were observed in the AC + BC10 and BF7 + BC10 treatments, respectively. Overall, our results suggested that the cyanide removal efficiency after 30 days of ensiling with good-quality cassava-root silage was approximately 39% of the initial value. The enterococci inoculants and/or AC could improve the ensiling process and cyanide removal efficiency (increasing it to between 47 and 51% of the initial value). The novel enterococci inoculants (BF7 + BC10) were associated with a decreased cyanide content and an increased CP content. They appeared to promote the methanogenesis potential of the cassava root silage. More research is required to validate the use of cyanide-utilizing bacterial inoculants in cyanogenetic plants, bioenergy fermentation, and livestock.

Understanding the nutritive values of fruit peel residues could expand our feed atlas in sustaining livestock production systems. This study aimed to investigate the effects of lactic acid bacteria (LAB), cellulase enzyme, molasses, and their combinations on the fermentation quality and in vitro digestibility of coconut peel (CCP), sugar palm peel (SPP), and durian peel (DRP) silage. The CCP, SPP, and DRP were ensiled in a small-scale silo without additive (control), and with LAB strain TH14 (TH14), molasses, or Acremonium cellulase (AC) using a small-scale silage preparation technique according to a completely randomized design. All fresh peels had sufficient factors for ensiling such as moisture content (78–83%), water-soluble carbohydrates (WSC, 4.20–4.61% dry matter (DM)), and epiphytic LAB population (104–105 colony-forming units (cfu)/g fresh matter (FM)). However, aerobic bacteria counts were high (107–109 cfu/g FM). The fiber content of these fruit peels was high, with lignin abundances ranging from 9.1–21.8% DM and crude protein was low (2.7–5.4% DM). After ensiling, the pH values of the silage were optimal (≤4.25) and lower (p < 0.01) for SPP silage. The addition of molasses+TH14, molasses+AC, and molasses+TH14+AC has the potential to enhance fermentation characteristics and improve chemical composition. Silages treated with molasses alone improved the in vitro digestibility of tropical fruit peels. The residue of tropical fruits has the potential to be used as an alternative feed source for ruminants. Adding molasses, TH14, and AC during silage preparation could improve its nutritive value and digestibility.