A typical proton CT (pCT) detector comprises a tracking system, used to measure the proton position before and after the imaged object, and an energy/range detector to measure the residual proton range after crossing the object. The Bergen pCT collaboration was established to design and build a prototype pCT scanner with a high granularity digital tracking calorimeter used as both tracking and energy/range detector. In this work the conceptual design and the layout of the mechanical and electronics implementation, along with Monte Carlo simulations of the new pCT system are reported. The digital tracking calorimeter is a multilayer structure with a lateral aperture of 27 cm × 16.6 cm, made of 41 detector/absorber sandwich layers (calorimeter), with aluminum (3.5 mm) used both as absorber and carrier, and two additional layers used as tracking system (rear trackers) positioned downstream of the imaged object; no tracking upstream the object is included. The rear tracker's structure only differs from the calorimeter layers for the carrier made of ∼200 μm carbon fleece and carbon paper (carbon-epoxy sandwich), to minimize scattering. Each sensitive layer consists of 108 ALICE pixel detector (ALPIDE) chip sensors (developed for ALICE, CERN) bonded on a polyimide flex and subsequently bonded to a larger flexible printed circuit board. Beam tests tailored to the pCT operation have been performed using high-energetic (50-220 MeV/u) proton and ion beams at the

The angular distribution of the flavor-changing neutral current decay B + → K + µ + µ − is studied in proton-proton collisions at a center-of-mass energy of 8 TeV. The analysis is based on data collected with the CMS detector at the LHC, corresponding to an integrated luminosity of 20.5 fb −1 . The forward-backward asymmetry A FB of the dimuon system and the contribution F H from the pseudoscalar, scalar, and tensor amplitudes to the decay width are measured as a function of the dimuon mass squared. The measurements are consistent with the standard model expectations.Published in Physical Review D as

Crystalline Bi1−xPrxFeO3 films were fabricated on Si (100) substrates by sol-gel technique. X-ray diffraction revealed a decrease of lattice constants of the doped samples evidencing substitution of Bi by Pr ions. Ferromagnetism with low saturation magnetization Ms = 1–3 emu/cm3 of the films were observed by Vibrating sample magnetometry. Systematic change of Mossbauer parameters of the films with Pr doped concentration increase were obtained by Conversion-electron Mossbauer spectroscopy (CEMS). The results of both one- and two-sextet fittings of the CEMS spectra provide evidence for destruction of the spin cycloid in Pr-doped BiFeO3.