Second-mode wave growth within the hypersonic boundary layer of a slender cone is investigated experimentally using high-speed schlieren visualizations. Experiments were performed in AEDC Tunnel 9 over a range of unit Reynolds number conditions at a Mach number of approximately 14. A thin lens with a known density profile placed within the field of view enables calibration of the schlieren set-up, and the relatively high camera frame rates employed allow for the reconstruction of time-resolved pixel intensities at discrete streamwise locations. The calibration in conjunction with the reconstructed signals enables integrated spatial amplification rates ($N$ factors) to be calculated for each unit Reynolds number condition and compared to $N$ factors computed from both pressure transducer measurements and linear parabolized stability equation (PSE) solutions. Good agreement is observed between $N$ factors computed from the schlieren measurements and those computed from the PSE solutions for the most-amplified second-mode frequencies. The streamwise development of $N$ factors calculated from the schlieren measurements compares favourably to that calculated from the pressure measurements with slight variations in the $N$ factor magnitudes calculated for harmonic frequencies. Finally, a bispectral analysis is carried out to identify nonlinear phase-coupled quadratic interactions present within the boundary layer. Multiple interactions are identified and revealed to be associated with the growth of disturbances at higher harmonic frequencies.

Experiments are performed to investigate the effect of nose-tip bluntness on the instability mechanisms leading to boundary-layer transition on a $7^{\circ }$ half-angle cone in a Mach-6 free stream. The development of disturbances is characterized using a combination of high-speed calibrated schlieren images and pressure measurements, and the data are compared with results computed using the parabolized stability equations. The approximately 414 mm long cone model is equipped with an interchangeable nose tip ranging from sharp to 5.08 mm in radius. For nose tips with a radius $R_{N}<2.54\ {\rm mm}$ , second-mode instability waves are the dominant mechanism leading to transition. Time-averaged frequency spectra computed from the calibrated schlieren visualizations and pressure measurements are used to compute the second-mode most-amplified frequencies and integrated amplification rates ( $N$ factors). Good agreement is observed between the measurements and computations in the linear-growth regime for the sharp-nose configuration at each free-stream condition. Additionally, a bispectral analysis identifies quadratic phase locking of frequency content responsible for the growth of higher harmonics. For nose tips of $R_{N}\geqslant 2.54\ {\rm mm}$ , the schlieren visualization region is upstream of the entropy-layer swallowing length, and second-mode waves are no longer visible within the boundary layer; instead, elongated, steeply inclined features believed to be associated with non-modal instability mechanisms develop between the entropy-layer and boundary-layer edges. Simultaneously acquired surface pressure measurements reveal high-frequency pressure oscillations similar to second-mode instability waves associated with the trailing edge of these non-modal features.

No abstract

A Nomarski polarizing prism has been used in conjunction with a focused laser differential interferometer to measure the phase velocity of a density disturbance at sampling frequencies ≥ 10 M H z . Use of this prism enables the simultaneous measurement of density disturbances at two closely spaced points that can be arbitrarily oriented about the instrument’s optical axis. The orientation is prescribed by rotating the prism about this axis. Since all four beams (one beam pair at each measurement point) propagate parallel to one another within the test volume, any bias imparted by density fluctuations away from the measurement plane on the disturbance phase velocity is minimized. A laboratory measurement of a spark-generated shock wave and a wind tunnel measurement of a second-mode instability wave on a cone model in a Mach 6 flow are presented to demonstrate the performance of the instrument. High-speed schlieren imaging is used in both cases to verify the results obtained with the instrument.

No abstract