Objective: The objective of this study is to develop a controlled release matrix tablet of candesartan cilexetil to reduce the frequency of administration, enhance bioavailability and improve patient compliance; a once daily sustained release formulation of candesartan cilexetil is desirable. Methods:The prepared tablets from F1 to F24 were evaluated with different evaluation parameters like weight variation, drug content, friability, hardness, thickness and swelling ability. In vitro release for all formulas were studied depends on the type and amount of each polymer, i.e. (16 mg, 32 mg and 48 mg) respectively beside to the combination effect of polymers on the release of the drug from the tablet. Results:In vitro release showed that formula 13 had the faster release (100% after 4 h) which contained acacia (1:1) and the lowest sustain release was showed for F7 (73% after 8 h) which contained HPMC K100M (1:1). Formula 1 was an 89 % release after 8 h which contain eudragit RS100; F4 was a 100 % release after 5 h which contain Na CMC, F10 was a 100% after 8 h which contain xanthan gum and F16 was a 100 % release after 5 h which contain tragacanth polymer. Formula 9 had a lower release than F7 and F8 respectively. Formula 7 can be used for sustain oral drug delivery of candesartan cilexetil while Formula 13 can be used in contrary as fast release tablets for faster response. Conclusion:Controlled drug delivery system is promising for less dosing and higher patient compliance.

The aim of present study was to develop gel formulation of microsponges of poorly soluble drug meloxicam (MLX) in order to enhance the release and dissolution of MLX which is the limitation for preparation in topical forms. Also skin delivery is an alternative administration for MLX that can minimize gastrointestinal (GI) side effects and improve patient compliance. The microsponges of MLX were prepared by quasi-emulsion solvent diffusion method.  The effects of drug:polymer ratio, stirring time and Eudragit polymer type on the physical characteristics of microsponges were investigated and characterized for production yield, loading efficiency, particle size, surface morphology, and in vitro drug release from microsponges. The selected microsponge formula was incorporated into gel. The prepared microsponge gel was evaluated as visual inspection, pH, spreadability, viscosity, in addition to in vitro drug release. The results showed that the microsponge formula with Eudragit L100 polymer had optimum physical properties and enhanced the dissolution and release of MLX when compared with other formulas and pure drug. MLX microsponge carbopol gel produced a significant (p<0.05) improvement of the in vitro release than pure MLX gel. Hence quasi emulsion solvent diffusion method was a promising method to produce MLX microsponges with markedly enhanced dissolution rate.  Keywords: Meloxicam, Microsponges, Gel.