Due to the reciprocating engine, a pulsating flow occurs in the turbine turbocharger, which experiences conditions far from the continuous flow scenario. In this work, the effects of the characteristics of the mass flow pulse, parameterized through amplitude, frequency and temporal gradient, are decoupled and studied via unsteady Computational Fluid Dynamics calculations under on-engine operating conditions. Firstly, the model is validated based on comparisons with experimental data in steady flow conditions. Then, the effect of each parameter on exergy budget is assessed by considering a +/-10% variation with respect to a baseline pulse. The other factors defining the operating conditions (e.g. mass flow, shaft speed and inflow exergy) are kept the same as the baseline. The adopted approach enables to completely isolate the effects of each parameter in contrast with previous literature studies. Based on the results observed, pulse amplitude is identified as the primary parameter affecting the hot-side system response in terms of turbine performance, heat transfer and entropy generation, while frequency and temporal gradient show a smaller influence compared to it. As the pulse amplitude increases, the turbine work is reported to improve up to 9.4%. Smaller variations are observed for the frequency and temporal gradient analysis. With a 10% increase of the pulse frequency the turbine work is registered to improve by 5.0%, while the same percentage reduction of the temporal gradient leads to an increase of turbine work equal to 3.6%.

Under on-engine operating conditions, a turbocharger turbine is subject to a pulsating flow and, consequently, experiences deviations from the performance measured in gas-stand flow conditions. Furthermore, due to the high exhaust gases temperatures, heat transfer further deteriorates the turbine performance. The complex interaction of the aerothermodynamic mechanisms occurring inside the hot-side, and consequently the turbine behavior, is largely affected by the shape of the pulse, which can be parameterized through three parameters: pulse amplitude, frequency, and temporal gradient. This paper investigates the hot-side system response to the pulse amplitude via Detached Eddy Simulations (DES) of a turbocharger radial turbine system including exhaust manifold. Firstly, the computational model is validated against experimental data obtained in gas-stand flow conditions. Then, two different mass flow pulses, characterized by a pulse amplitude difference of 5%, are compared. An exergy-based post-processing approach shows the beneficial effects of increasing the pulse amplitude. An improvement of the turbine power by 1.3%, despite the increment of the heat transfer and total internal irreversibilities by 5.8% and 3.4\%, respectively, is reported. As a result of the higher maximum speeds, internal losses by viscous friction are responsible for the growth of the total internal irreversibilities as pulse amplitude increases.

No abstract

The behaviour of collapsed or stenotic vessels in the human body can be studied by means of simplified geometries like a collapsible tube. The objective of this work is to determine the value of the buckling critical pressure of a collapsible tube by employing Landau’s theory of phase transition. The methodology is based on the implementation of an experimentally validated 3D numerical model of a collapsible tube. The buckling critical pressure is estimated for different values of geometric parameters of the system by treating the relation between the intramural pressure and the area of the central cross-section as the order parameter function of the system. The results show the dependence of the buckling critical pressures on the geometric parameters of a collapsible tube. General non-dimensional equations for the buckling critical pressures are derived. The advantage of this method is that it does not require any geometric assumption, but it is solely based on the observation that the buckling of a collapsible tube can be treated as a second-order phase transition. The investigated geometric and elastic parameters are sensible for biomedical application, with particular interest to the study of the bronchial tree under pathophysiological conditions like asthma.

No abstract