In thermal-barrier experiments in the tandem mirror experiment upgrade, axial confinement times of 50 to 100 ms have been achieved. During enhanced confinement we measured the thermal-barrier potential profile using a neutral-particle-beam probe. The experimental data agree qualitatively and quantitatively with the theory of thermal-barrier formation in a tandem mirror.

No abstract

We have designed and built a Dense Plasma Focus (DPF) Z-pinch device using a kJ-level capacitor bank and a hollow anode, and fueled by a cylindrically symmetric gas puff. Using this device, we have measured peak deuteron beam energies of up to 400 keV at 0.8 kJ capacitor bank energy and pinch lengths of ∼6 mm, indicating accelerating fields greater than 50 MV/m. Neutron yields of on the order of 10(7) per shot were measured during deuterium operation. The cylindrical gas puff system permitted simultaneous operation of DPF with a radiofrequency quadrupole accelerator for beam-into-plasma experiments. This paper describes the machine design, the diagnostic systems, and our first results.

Laser conditioning has been shown to improve the laser damage threshold of some optical coatings by greater than 2x. Debate continues within the damage community regarding laser-conditioning mechanisms, but it is clear that nodular ejection is one of the byproducts of the laser conditioning process. To better understand why laser conditioning is so effective, photothermal microscopy was used to measure absorption of coating defects before and after laser exposure. Although a modest absorption reduction was expected due to the lower electric field peaks within a pit and the absence of potentially absorbing nodular seeds, surprisingly, absorption reductions up to 150x were observed. Photothermal microscopy has also been successfully used to correlate laser-induced damage threshold and absorption of defects in hafnidsilica multilayer optical coatings. Defects with high absorption, as indicated by high photothermal signal, have low damage thresholds. Previously a linear correlation of damage threshold and defect photothermal signal was established with films designed and damage tested at lw (1053 nm) and Brewster's angle (56.4"), but characterized by photothermal microscopy at 514.5 nm and near-normal angle of incidence (10"). In this study coatings designed, characterized by photothermal microscopy, and damage tested at the same wavelength, incident angle, and polarization did not have a correlation between defect photothermal signal and absorption.

Ion cyclotron heating (ICH) is applied to TMX-U to improve the thermal barrier performance by reducing the passing ion collisionality. During its development, measurements of the antenna loading resistance, R , and the absorption efficiency, rj, were compared with calculations with the antenna design code ANTENA over a wide range of densities and frequencies. Good agreement in R was obtained in the short wavelength slow wave regime but not for long wavelength fast waves because the experimental magnetic field gradients are not modelled in ANTENA. Similarly, r) is much larger experimentally (40%) than in ANTENA (10%) due to the magnetic beach in TMX-U. In its application, ICH successfully decreased the passing ion collisionality tenfold but did not extend thermal barrier plugging to higher density, indicating that collisional barrier filling is not currently limiting TMX-U performance.