We treated 32 displaced mallet finger fractures by a two extension block Kirschner-wire technique. The clinical and radiological outcomes were evaluated at a mean follow-up of 49 months (25 to 84). The mean joint surface involvement was 38.4% (33% to 50%) and 18 patients (56%) had accompanying joint subluxation. All 32 fractures united with a mean time to union of 6.2 weeks (5.1 to 8.2). Congruent joint surfaces and anatomical reduction were seen in all cases. The mean flexion of the distal interphalangeal joints was 83.1 degrees (75 degrees to 90 degrees ) and the mean extension loss was 0.9 degrees (0 degrees to 7 degrees ). No digit had a prominent dorsal bump or a recurrent mallet deformity. We believe that this technique, when properly applied, produces satisfactory results both clinically and radiologically.

It has been suggested that the increased frequency of trigger finger (TF) after carpal tunnel release (CTR) may be caused by the volar migration of the flexor tendons at the wrist altering the tendon biomechanics at the A1 pulley. This hypothesis has not been validated. We performed pre- and post-operative ultrasonography (USG) on the affected wrists of 92 patients who underwent CTR. Pre-operative USG was performed in neutral with no tendon loading; post-operative USG was performed in neutral unloaded and in various positions of wrist flexion whilst loading the flexor tendons with gripping. The mean volar migration of the flexor tendons after CTR was 2.2 (SD 0.4) mm in the unloaded neutral position. It was 1.8 (SD 0.4) mm in patients who did not develop TF and 2.5 (SD 0.5) mm in those who did (p = 0.0067). In loaded wrist flexion, the mean volar migration of flexor tendons after CTR in patients who did not develop TF and those who did was 2.1 and 3.0 mm in 0° flexion; 3.2 and 3.9 mm in 15° flexion; 4.3 and 5.1 mm in 30° flexion; and 4.9 and 5.8 mm in 45° flexion, respectively. There were significant differences between patients with and without TF at each flexion angle. Our data indicate that patients with greater volar migration of the flexor tendons after CTR are more likely to develop TF. This conclusion supports the hypothesis that the occurrence of TF after CTR may be caused by the bowstringing effects of the flexor tendons.

The aims of this study were to assess the efficacy of a newly designed radiological technique (the radial groove view) for the detection of protrusion of screws in the groove for the extensor pollicis longus tendon (EPL) during plating of distal radial fractures. We also aimed to determine the optimum position of the forearm to obtain this view. We initially analysed the anatomy of the EPL groove by performing three-dimensional CT on 51 normal forearms. The mean horizontal angle of the groove was 17.8° (14° to 23°). We found that the ideal position of the fluoroscopic beam to obtain this view was 20° in the horizontal plane and 5° in the sagittal plane. We then intra-operatively assessed the use of the radial groove view for detecting protrusion of screws in the EPL groove in 93 fractures that were treated by volar plating. A total of 13 protruding screws were detected. They were changed to shorter screws and these patients underwent CT scans of the wrist immediately post-operatively. There remained one screw that was protruding. These findings suggest that the use of the radial groove view intra-operatively is a good method of assessing the possible protrusion of screws into the groove of EPL when plating a fracture of the distal radius.