The constitutive response of a commercial magnesium alloy rolled sheet (AZ31B-O) is studied based on room temperature tensile and compressive tests at strain rates ranging from 10 −3 to 10 3  s −1 . Because of its strong basal texture, this alloy exhibits a significant tension–compression asymmetry (strength differential) that is manifest further in terms of rather different strain rate sensitivity under tensile versus compressive loading. Under tensile loading, this alloy exhibits conventional positive strain rate sensitivity. Under compressive loading, the flow stress is initially rate insensitive until twinning is exhausted after which slip processes are activated, and conventional rate sensitivity is recovered. The material exhibits rather mild in-plane anisotropy in terms of strength, but strong transverse anisotropy ( r -value), and a high degree of variation in the measured r -values along the different sheet orientations which is indicative of a higher degree of anisotropy than that observed based solely upon the variation in stresses. This rather complex behaviour is attributed to the strong basal texture, and the different deformation mechanisms being activated as the orientation and sign of applied loading are varied. A new constitutive equation is proposed to model the measured compressive behaviour that captures the rate sensitivity of the sigmoidal stress–strain response. The measured tensile stress–strain response is fit to the Zerilli–Armstrong hcp material model.

No abstract

Strain rate sensitivity (SRS) is an important material property that governs the rate dependent mechanical behaviors associated with deformation rate changes, creep, stress relaxation, formability, etc. The variety of activated deformation mechanisms of magnesium alloys under different loading paths, e.g. tension vs. compression, implies that SRS of magnesium alloys obviously depends on loading paths, and each deformation mechanism has its own SRSs. However, a single SRS scheme is commonly employed in numerical modeling to describe the rate dependent behaviors of magnesium alloys, which disregards the distinction of SRSs among different deformation mechanisms. The implementation of the constitutive model that works for a wide range of values of SRSs has been a challenge to crystal plasticity modeling for metals with multiple deformation mechanisms like magnesium. Especially, very small values of SRS, corresponding to low rate-sensitivity, generally lead to high nonlinearity involved in the governing equations, and then computational failure. In this paper, the elasto-viscoplastic selfconsistent (EVPSC) crystal plasticity model is improved to enhance its numerical robustness for very small SRS values. Taking advantage of this improvement, different SRSs for various deformation mechanisms are employed to investigate the strain rate dependent behaviors of magnesium alloys at room temperature. First, the SRSs for various deformation mechanisms are determined based on the compressive stress relaxation tests on an AZ31 alloy plate; secondly, the obtained SRSs are applied to interpret internal elastic strain evolution of the same magnesium alloy under in-plane compression; finally, the determined SRSs are applied to investigate the deformation of another AZ31 alloy under various deformation paths and strain rates. The present work is the first effort on studying effects of strain rate-sensitivity on mechanical behavior of Mg alloys under wide range of applied strain rates by using an improved self-consistent polycrystal plasticity model. Good agreement between the experiments and simulations reveals the importance and necessity of using different SRSs for the deformation mechanisms involved. The rate dependent behaviors of magnesium alloys can be better described by using multiple SRSs associated to each operative deformation mechanism.

No abstract

No abstract