No abstract

No abstract

Perovskite-type oxides with transition elements offer promising potential as catalysts in total oxidation reactions. The present work reports the synthesis of crystalline lanthanum nickelates and cobaltates and their intermediate nanomaterials compositions LaNi1-XCoXO3 (x = 0.3, 0.5, and 0.7) at 800 ºC by co-precipitation precursor technique for structural, morphological, and total propylene oxidation catalytic activity. The evolution of the crystal structure and formation of the perovskite phase were analyzed by X-ray diffraction, Thermo Gravimetry Analysis (TGA) / Differential Scanning Calorimetry (DSC), Fourier Transformed Infra-Red (FTIR), Atomic Absorption Spectroscopy (AAS), Scanning Electron Microscopy (SEM), Brunauer–Emmett–Teller (BET), Electron Spin Resonance (ESR) techniques. The terminal compounds LaNiO3, LaCoO3, and their intermediates compositions were identified to be single-phase and are indexed to rhombohedral structures. The bonding characteristics were studied by FTIR spectroscopy. On substitution of Ni with Co in B-site, the slight distortion in XRD diffraction peaks were observed. These compounds show a considerable increase in the activity of propylene oxidation to carbon dioxide. This study aims at understanding the effect of B– site substitution in the lattice of LaNiO3 and their influence on catalytic propylene oxidation efficiency.

Perovskite-type structures LaBO3 with the compositions of LaMn1-xCoxO3 (x = 0.0, 0.3, 0.5, 0.7, and 1.0) were synthesized at 800 °C by a modified co-precipitation precursor technique for total oxidation of propylene, as a model test of the hydrocarbon oxidation reaction. Details concerning the evolution of the crystal structure, morphology, and crystallite size were performed by X-ray diffraction (XRD), Thermo Gravimetry Analysis (TGA)/Differential Scanning Calorimetry (DSC), Fourier Transform Infra-Red (FTIR), Atomic Absorption Spectroscopy (AAS), Scanning Electron Microscopy (SEM), and Electron Spin Resonance (ESR) techniques. All compositions were identified to be single-phase and are indexed to rhombohedral structures. TG/DSC technique evidenced a temperature of 330 °C needed for the precursor as the start point and 800 °C completion for perovskite phase formation. Slight distortion in XRD diffraction peaks was observed on substituting manganese with cobalt in B-site, and new peaks emerged. An attempt has been made to understand the effect of the B-site substitution of Co3+ ions in the lattice of LaMnO3 and their influence on catalytic total propylene oxidation efficiency. These compounds show a considerable increase in the activity of propylene oxidation to carbon dioxide and water and could be explored for hydrocarbon pollution control.

Ferrite material nanoparticles comprised of manganese and zinc were chemically synthesized by the co-precipitation method. The designated ferrite X-ray diffraction peaks and characteristic ferrite absorption bands in Fourier transform infrared absorption spectra confirmed the formation of a spinel structure. Determination of the full width at half maximum values of the X-ray diffraction peaks and the corresponding calculations using the Scherrer formula suggested the generation of nano-grains. Micrographs obtained using a transmission electron microscope confirmed the nano-scale dimensions of the particles. Deviations in the characteristic resistivity and thermopower values in response to ambient sample temperature variations were experimentally observed and used for correlation-derived temperature-dependent transport behaviour analysis. Samples with a concentration x = 0.8 and 1.0 showed high thermopower values at reasonably low temperatures with moderate specific resistance.