The use of scanning probe microscopy-based techniques to manipulate single molecules and deliver them in a precisely controlled manner to a specific target represents a significant nanotechnological challenge. The ultimate physical limit in the design and fabrication of organic surfaces can be reached using this approach. Here we show that the atomic force microscope (AFM), which has been used extensively to investigate the stretching of individual molecules, can deliver and immobilize single molecules, one at a time, on a surface. Reactive polymer molecules, attached at one end to an AFM tip, are brought into contact with a modified silicon substrate to which they become linked by a chemical reaction. When the AFM tip is pulled away from the surface, the resulting mechanical force causes the weakest bond - the one between the tip and polymer - to break. This process transfers the polymer molecule to the substrate where it can be modified by further chemical reactions.

The very first characterization of the structural properties of polymer films obtained by electrografting is reported. AFM-based force spectroscopy was used to investigate poly-N-succinimidyl acrylate (PNSA) layers electrografted directly from a silicon substrate. Quantitative analysis of compression profiles obtained in a good solvent and single molecule bridging interaction, in light of the Alexander−de Gennes model, gave access to the grafting density and degree of polymerization. A high swelling capacity has been evidenced. This report is the first evidence that polymers obtained by cathodic electrografting are in fact brush systems, and consequently the first evidence that a polymer brush can be obtained from a direct “grafting from” method, without any intermediate layer.

Two strategies were used for the preparation of hyperbranched polymer brushes with a high density of functional groups: (a) the cathodic electrografting of stainless steel by poly[2-(2-chloropropionate)ethyl acrylate] [poly(cPEA)], which was used as a macroinitiator for the atom transfer radical polymerization of an inimer, 2-(2-bromopropionate)ethyl acrylate in the presence or absence of heptadecafluorodecyl acrylate, (b) the grafting of preformed hyperbranched poly(ethyleneimine) onto poly(N-succinimidyl acrylate) previously electrografted onto stainless steel. The hyperbranched polymer, which contained either bromides or amines, was quaternized because the accordingly formed quaternary ammonium or pyridinium groups are known for antibacterial properties. The structure, chemical composition, and morphology of the quaternized and nonquaternized hyperbranched polymer brushes were characterized by ATR-FTIR reflectance, Raman spectroscopy, X-ray photoelectron spectroscopy, and atomic force microscopy. The peeling test confirmed that the grafted hyperbranched polymer films adhered much more strongly to stainless steel than the nongrafted solvent-cast films. The quaternized hyperbranched polymer brushes were more effective in preventing both protein adsorption and bacterial adhesion than quaternary ammonium containing poly(cPEA) primary films, more likely because of the higher hydrophilicity and density of cationic groups.