In this paper, a dielectric barrier discharge cylindrical reactor has been analyzed in order to increase the efficiency of nitrogen oxide (NO x ) removal from the simulated gas under the room temperature. The effects of electrode shape as well as electrode diameter and electrode length are investigated in the nonthermal plasma reactor. Two different electrode configurations (rod and screw thread electrodes) are examined. The experimental result shows that for the rod electrode, NO x removal efficiency is enhanced by increasing the electrode diameter. However, the screw thread electrode is more effective in decreasing NO x concentration. Finally, the results showed that the average input power requirement for NO x removal can be reduced almost 14% using a 1-mm screw thread electrode instead of a rod electrode.Index Terms-Dielectric barrier discharge (DBD) reactor, electrode configuration, NO x removal, nonthermal plasma (NTP), rod electrode, screw thread electrode.
Non-thermal plasma (NTP) has been introduced over the last few years as a promising after- treatment system for nitrogen oxides and particulate matter removal from diesel exhaust. NTP technology has not been commercialised as yet, due to its high rate of energy consumption. Therefore, it is important to seek out new methods to improve NTP performance. Residence time is a crucial parameter in engine exhaust emissions treatment. In this paper, different electrode shapes are analysed and the corresponding residence time and NOx removal efficiency are studied. An axisymmetric laminar model is used for obtaining residence time distribution numerically using FLUENT software. If the mean residence time in a NTP plasma reactor increases, there will be a corresponding increase in the reaction time and consequently the pollutant removal efficiency increases. Three different screw thread electrodes and a rod electrode are examined. The results show the advantage of screw thread electrodes in comparison with the rod electrode. Furthermore, between the screw thread electrodes, the electrode with the thread width of 1 mm has the highest NOx removal due to higher residence time and a greater number of micro-discharges. The results show that the residence time of the screw thread electrode with a thread width of 1 mm is 21% more than for the rod electrode.
In this paper, a comprehensive study of a DBD reactor is conducted to investigate the optimum operating conditions of the reactor for NOx treatment. For each parameter, the objective is to find the maximum NOx removal efficiency with the minimum consumed power. Different effective parameters of the reactor i.e. electrode length and diameter, electrode and dielectric materials as well as parameters of power generator, i.e. voltage and frequency, are investigated. The results show that for this configuration, the electrode with 20 cm length and 10 mm diameter has the best performance. Aluminum as the inside electrode material and quartz as the dielectric material are selected. Furthermore, the optimum value for the pulse frequency is 16.6 kHz. For the mentioned optimum conditions, the NOx removal efficiency achieved is equal to almost 82% at the input power of 486 W. Furthermore, the highest achieved NOx removal is almost 92% at the input power of 864 W. The results of this paper can be used to reduce the energy consumption of NTP systems to acceptable levels.
Introduction: Smoking as one of the causes of various diseases has encouraged worldwide studies on its adverse pharmacological effects on different organs. Nicotine may influence the smooth muscles of the colon and subsequently the gut motility, which leads to a change in the moving rate of digested material through the gastrointestinal tract. Methods: Among various techniques, optical detection methods benefit from non-contact and highsensitivity for studying the early effect of nicotine on the cells. Thus, we used an optically ellipsometric method to get the fast and sensitive nicotine effect on the colon cell. Two-dimensional plasmonic platforms by gold deposition onto the polydimethylsiloxane polymer (PDMS) patterned substrate were used as the guest medium of the cell and the sample was excited by all of the visible region wavelengths at different exposure time and maintenance time. Results: Our results showed that the phase difference between each polarization increased by augmenting the exposure time of smoke over the cell at a fixed maintenance time and there was a general red-shift by increasing the maintenance time at a fixed exposure time. Conclusion: Using different exposure time to cigarette smoke, we optically showed that the cigarette containing the addicting chemical of nicotine had a direct effect on the cultured colon cells on our 2D biocompatible plasmonic chip. It demonstrated considerable changes in the amplitude and phase of the interacted light by injecting nicotine into the system with the aid of the label-free and non-invasive plasmonic technique
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.