No abstract

<p>Protection of equipment, safety of persons and continuity of power supply are the main objectives of the grounding system. For its accurate design, it is essential to determine the potential distribution on the earth surface and the equivalent resistance of the system. The knowledge of such parameters allows checking the security offered by the grounding system when there is a failure in the power systems.A new method to design an earthing systems using Finite Element Method (FEM) is presented in this article.In this approach, the influence of the moisture and temperature on the behavior of soil resistivity are considered in EARTHING system DESIGN. The earthing system is considered to be a rod electrode and a plate type electrode buried vertically in the ground.The resistance of the system which is a very important factor in the design process is calculated using Finite Element Method. Finite Element Method is used to estimate the solution of the partial differential equation that governs the system behavior. COMSOL Multiphysics 4.4 which is one of the packages that work with the FEM is used as a tool in this design.Finally the values of the resistance obtained by COMSOL Multiphysics are compared with the proven analytical formula values for the ground resistance, in order to prove the work done with COMSOL Multiphysics.</p>

No abstract

<p>The most of the new protective schemes are based on a communication channel, which cannot be guaranteed in practice. However, during blackouts or cascading failures in the power grid, as system conditions change significantly and rapidly, more information exchanges may be required by the control centers and substations. In other words, the communication channels are operating with high load and therefore become more vulnerable when the power grid is in contingent conditions. Thus, relying on the communication channel for decision making may not be the optimal solution for protective relays, although it might be beneficial to have information exchange. In this article, a novel protective logic is proposed based on phasor measurement units (PMUs) data for optimal coordination of overcurrent relays. PMUs measure the positive sequence voltage at two substations separated by hundreds of miles which are synchronized precisely with the aid of a GPS satellite system. The precise time-tags are attached with samples, and this information is exchanged over communication channels and collected by control centers and/or substations. By extracting the relevant information from these measurements, phasor information can be obtained at any node where PMUs are installed in the power grid. This can be used to do more accurate state estimation, control, and protection. In these relays, besides current and voltage, phasor information has become an important measurement in decision making. The proposed method is tested on IEEE 8-bus standard network.</p>