BackgroundPrealbumin, a sensitive marker for protein–energy status, is also known as an independent risk factor for mortality in hemodialysis patients. We investigated the impact of prealbumin on survival in incident peritoneal dialysis (PD) patients.MethodsIn total, 136 incident PD patients (mean age, 53.0 ± 15.8 years) between 2002 and 2007 were enrolled in the study. Laboratory data, dialysis adequacy, and nutritional parameters were assessed 3 months after PD initiation. Patients were classified into 2 groups according to prealbumin level: high prealbumin (≥ 40 mg/dL) and low prealbumin (< 40 mg/dL).ResultsThe patients in the low-prealbumin group were older and had more comorbidities such as diabetes and cardiovascular diseases compared with the patients in the high-prealbumin group. Mean subjective global assessment scores were lower, and the high-sensitivity C-reactive protein levels were higher in the low-prealbumin group. Serum creatinine, albumin, and transferrin levels; percent lean body mass; and normalized protein catabolic rate were positively associated, whereas subjective global assessment scores and high-sensitivity C-reactive protein levels were negatively associated with prealbumin concentration. During the median follow-up of 49 months, patients in the lower prealbumin group had a higher mortality rate. Multivariate analysis revealed that prealbumin < 40 mg/dL (hazard ratio, 2.30; 95% confidence interval, 1.14–4.64) was an independent risk factor for mortality. In receiver operating characteristic curves, the area under the curve of prealbumin for mortality was the largest among the parameters.ConclusionPrealbumin levels were an independent and sensitive predictor for mortality in incident PD patients, showing a good correlation with nutritional and inflammatory markers.

Background/Aims:This study analyzed the risk factors for technique survival in dialysis patients and compared technique survival rates between hemodialysis (HD) and peritoneal dialysis (PD) in a prospective cohort of Korean patients.Methods:A total of 1,042 patients undergoing dialysis from September 2008 to June 2011 were analyzed. The dialysis modality was defined as that used 90 days after commencing dialysis. Technique survival was compared between the two dialysis modalities, and the predictive risk factors were evaluated.Results:The dialysis modality was an independent risk factor predictive of technique survival. PD had a higher risk for technique failure than HD (hazard ratio [HR], 10.8; 95% confidence interval [CI], 1.9 to 62.0; p = 0.008) during a median follow-up of 11.0 months. In the PD group, a high body mass index (BMI) was an independent risk factor for technique failure (HR, 1.3; 95% CI, 1.0 to 1.8; p = 0.036). Peritonitis was the most common cause of PD technique failure. The difference in technique survival between PD and HD was more prominent in diabetic patients with a good nutritional status and in non-diabetic patients with a poor nutritional status.Conclusions:In a prospective cohort of Korean patients with end-stage renal disease, PD was associated with a higher risk of technique failure than HD. Diabetic patients with a good nutritional status and non-diabetic patients with a poor nutritional status, as well as patients with a higher BMI, had an inferior technique survival rate with PD compared to HD.

L'DISQ can be successfully navigated to the target zones, and disc tissue ablated without thermal or structural damage to the adjacent neural tissues.

Background/Aims:Little is known regarding the incidence rate of and factors associated with developing chronic kidney disease after continuous renal replacement therapy (CRRT) in acute kidney injury (AKI) patients. We investigated renal outcomes and the factors associated with incomplete renal recovery in AKI patients who received CRRT.Methods:Between January 2011 and November 2013, 408 patients received CRRT in our intensive care unit. Of them, patients who had normal renal function before AKI and were discharged without maintenance renal replacement therapy (RRT) were included in this study. We examined the incidence of incomplete renal recovery with an estimated glomerular filtration rate < 60 mL/min/1.73 m2 and factors that increased the risk of incomplete renal recovery after AKI.Results:In total, 56 AKI patients were discharged without further RRT and were followed for a mean of 8 months. Incomplete recovery of renal function was observed in 20 of the patients (35.7%). Multivariate analysis revealed old age and long duration of anuria as independent risk factors for incomplete renal recovery (odds ratio [OR], 1.231; 95% confidence interval [CI], 1.041 to 1.457; p = 0.015 and OR, 1.064; 95% CI, 1.001 to 1.131; p = 0.047, respectively). In a receiver operating characteristic curve analysis, a cut-off anuria duration of 24 hours could predict incomplete renal recovery after AKI with a sensitivity of 85.0% and a specificity of 66.7%.Conclusions:The renal outcome of severe AKI requiring CRRT was poor even in patients without further RRT. Long-term monitoring of renal function is needed, especially in severe AKI patients who are old and have a long duration of anuria.

Shape memory alloys (SMAs) have a special ability to remember their initial shape and return from operating temperature. For this special ability, there are many studies in the field of smart wearables to replace rigid, heavy, and large electric actuators with SMAs that can be a fabrication. The usual operating method of the SMA is heating the SMA by direct Joule heating with electricity. Although direct Joule heating is fast and easy, there is overshooting, unstable, and high-power consumption. For these issues to use the SMA as textile actuators, this research suggested a heating method with silver paste required lower power consumption and coating the basic fabric with carbon nanotubes (CNTs) to support heating stability and heat uniformity. The heating method evaluated the efficiency of heat by comparing direct heating and silver layer heating and the uniformity of heat with the infrared images of whether CNTs coated or not. In this research, we reached higher temperatures with lower power than direct Joule heating using wearable heaters manufactured using silver paste. In addition, we confirmed that coating the basic fabric with carbon nanotubes reduce the temperature imbalance, and improved the heating stability. This research is expected that SMA will be used as a wearable actuator to help develop wearable devices that can move.