No abstract

Abstract:The solid host of a laser dye modifies its spectroscopic properties with respect to its liquid host. During the Sol-Gel process the dye molecules suffer from changing their environment. Two parameters affect this matter, the change in the concentration due to the evaporation of the solvent (drying) and the caging of dye molecules inside the pores or attachment to the silica network. Rhodamine 6G absorption and fluorescence spectra with different concentrations, during Sol-Gel time processing, have been studied. Both, absorption and fluorescence spectra of the dye in the solid host, for different concentrations, show a blue-shift relative to its liquid phase.

In this work, a reactive DC magnetron sputtering technique was used to prepare TiO2 thin films. The variation in argon and oxygen gases mixing ratios (4:1, 2:1, 1:1, 1:2, 1:4) was used to achieve optimal properties for gas sensing. In addition, an analysis of the optical XRD properties of TiO2 thin films is presented. High-quality and uniform nanocrystalline films were obtained at a working gas pressure of 0.25 mbar and  1:4 (Ar/O2) gas mixture. The optical properties showed a transparent thin film with uniform adherence to the substrate. The average transmission of the TiO2 films deposited on the glass substrates was higher than 95% over the range of 400 to 800 nm.  The optical band gap varied from 3.84 eV to 3.93 eV as a function of oxygen/argon ratios. The XRD pattern showed that the films have an amorphous structure, which is shifted to polycrystalline with increasing oxygen to argon ratio. The sensitivity, response time, and recovery time were measured for TiO2 thin films using NO2 oxidizing gas.

Well dispersed Cu2FeSnSe4 (CFTSe) nanofilms were synthesized by hot-injection method. The structural and morphological measurements were characterized using XRD (X-ray diffraction), Raman spectroscopy, SEM (scanning electron microscopy), and TEM (transmission electron microscopy). Chemical composition and optical properties of as-synthesized CFTSe nanoparticles were characterized using EDS (energy dispersive spectroscopy) and UV-Vis spectrophotometry. The average particle size of the nanoparticles was about 7-10 nm. The UV-Vis absorption spectra showed that the synthesized CFTS nanofilms have a band gap (Eg) of about 1.16 eV. Photo-electrochemical characteristics of CFTSe nanoparticles were studied and indicated their potential application in photovoltaic applications.

Attempts were made over the years to achieve economic and easy methods for water purification. This could well save time, cost, and earn a good process quality for many countries. This study aims to enhance the purification process parameters for Congo red dye polluted water  and introduce a developed methodology with an impact on many associated parameters such as the time for water purification process.  The research  proposes  a method to achieve this time reduction by mixing gold nanoparticle (AuNPs) (prepared by chemical reduction method) with Titanium dioxide nanoparticles (TiO2NPs) (prepared by sol-gel techniques). The resulting mixture is incorporated into PVA host to synthesize a hard disk used as a purification disk to treat the pollutant water. The pollutant solution was exposed to different light sources to complete the photocatalyst process. In this respect, sunlight, UV ligh, green laser, blue laser, and combined UV light and green laser were used as a photocatalysis sources. Experimental work was conducted to adjust the right mixture and the right combination of light sources. Results were recorded accordingly and showed a significant reduction in the purification time with less than half the standard period when the conventional purification process is used.