A new and general approach to achieving efficient electrically driven light emission from a Si-based nano p-n junction array is introduced. A wafer-scale array of p-type silicon nanotips were formed by a single-step self-masked dry etching process, which is compatible with current semiconductor technologies. On top of the silicon nanotip array, a layer of n-type ZnO film was grown by pulsed laser deposition. Both the narrow line width of 10 nm in cathodoluminescence spectra and the appearance of multiphonon Raman spectra up to the fourth order indicate the excellent quality of the ZnO film. The turn-on voltage of our ZnO/Si nanotip array is found to be approximately 2.4 V, which is 2 times smaller than its thin film counterpart. Moreover, electroluminescence (EL) from our ZnO/Si nanotips array light-emitting diode (LED) has been demonstrated. Our results could open up new possibilities to integrate silicon-based optoelectronic devices, such as highly efficient LEDs, with standard Si ultralarge-scale integrated technology.

Convenient, rapid, and accurate detection of chemical and biomolecules would be a great benefit to medical, pharmaceutical, and environmental sciences. Many chemical and biosensors based on metal nanoparticles (NPs) have been developed. However, as a result of the inconvenience and complexity of most of the current preparation techniques, surface plasmon-based test papers are not as common as, for example, litmus paper, which finds daily use. In this paper, we propose a convenient and practical technique, based on the photothermal effect, to fabricate the plasmonic test paper. This technique is superior to other reported methods for its rapid fabrication time (a few seconds), large-area throughput, selectivity in the positioning of the NPs, and the capability of preparing NP arrays in high density on various paper substrates. In addition to their low cost, portability, flexibility, and biodegradability, plasmonic test paper can be burned after detecting contagious biomolecules, making them safe and eco-friendly.

We demonstrate superluminal light propagation using two frequency multiplexed pump beams to produce a gain doublet in a photorefractive crystal of Ce:BaTiO(3). The two gain lines are obtained by two-wave mixing between a probe field and two individual pump fields. The angular frequencies of the pumps are symmetrically tuned from the frequency of the probe. The frequency difference between the pumps corresponds to the separation of the two gain lines; as it increases, the crystal gradually converts from normal dispersion without detuning to an anomalously dispersive medium. The time advance is measured as 0.28 sec for a pulse propagating through a medium with a 2 Hz gain separation, compared to the same pulse propagating through empty space. We also demonstrate directly anomalous dispersion profile using a modified experimental configuration. Finally, we discuss how anomalous dispersion produced this way in a faster photorefractive crystal (such as SPS: Sn(2)P(2)S(6)) could be employed to enhance the sensitivity-bandwidth product of a LIGO type gravitational wave detector augmented by a White Light Cavity.