New graphene/polymer nanocomposites were prepared using graphene nanoplatelets (GNPs) and the epoxy system Epilok 60-566/Curamine 32-494. The GNPs were first dispersed into the curamine hardener using bath ultrasonication, followed by the addition of the epoxy resin. The cure kinetics were studied by DSC under non-isothermal and under isothermal conditions. The kinetic parameters of the curing process were determined using the non-isothermal Kissinger and Ozawa-Flynn-Wall models. The degree of curing increased with the addition of GNPs, while the activation energy decreased by 13.7% for the first reaction and by 6.6% for the second as obtained from Kissinger. An increase in thermal stability by the addition of GNPs was identified in the range of 360-580℃ using TGA. In terms of mechanical properties, addition of an optimum amount of 0.5%wt of GNPs in the hardener improved the Young's Modulus by 37%. Nanoindentation measurements showed 9.4% improvement in hardness at 0.7%wt.

No abstract

In this work, we report the synthesis and study of nanocomposites with a biobased epoxy/amine (Epilok 60-600G/Curamine 30-952) matrix reinforced with reduced graphene oxide (rGO) or functionalised with 3-glycidoxypropyltrimethoxysilane (GLYMO-rGO). These graphene related materials (GRMs) were first dispersed into a Curamine hardener using bath ultrasonication, followed by the addition of epoxy resin. Curing kinetics were studied by DSC under non-isothermal and isothermal conditions. The addition of 1.5 wt% of GLYMO-rGO into the epoxy matrix was found to increase the degree of cure by up to 12% and glass transition temperature by 14 °C. Mechanical testing showed that the addition of 0.05 wt% GLYMO-rGO improves Young’s modulus and tensile strength by 60% and 16%, respectively, compared to neat epoxy. Carbon fibre reinforced polymer (CFRP) laminates were prepared via hand lay up, using the nanocomposite system GRM/Epilok/Curamine as matrix, and were cut as CFRP adherents for lap shear joints. GRM/Epilok/Curamine was also used as adhesive to bond CFRP/CFRP and CFRP/aluminium adherents. The addition of 0.1 wt% GLYMO-rGO into the adhesive and CRFP adherents showed improved lap shear strength by 23.6% compared to neat resin, while in the case of CFRP/Aluminium joints the increase was 21.2%.

No abstract

Battery failures are obvious after being subject to abuse conditions however predicting these failures in advance is crucial when using test and validation techniques to understand battery potential. Lithium-ion battery cells are widely used due to their high energy and power densities. When abusive conditions like the three point bend loading are applied to lithium-ion batteries, what occurs to the mechanical behaviours and components is still mostly unknown. To further this understanding, this paper investigates the mechanical behaviour of the separator in the LiCoO2/Graphite cylindrical 18650 cells. Internal short circuit (ISC) behaviour, strain rate dependency and electrochemical status of the cells (i.e. SOC dependency) are studied to understand failure pattern. Furthermore, simple and effective constitutive model for the separator layer is formed, facilitating further mechanical analysis and numerical simulation of lithium-ion battery study. Occurrence of ISC is investigated by jellyroll deformation where casing is removed, and quasi-static load is applied. Numerical simulation model is developed to further investigate sequential structural failures and temperature changes. Simulation results showed good accuracy with experimental results and are useful to predict structural failure of cells. Number of failures including electrolyte leakage, change in shape, sudden voltage drop/temperature rise, and gas venting are observed.