Supercontinuum generation in a highly nonlinear fiber pumped by noise-like pulses from an erbium-doped fiber ring laser is investigated. To generate ultrabroad spectra, a fiber amplifier is used to boost the power launched into the highly nonlinear fiber. After amplification, not only the average power of the noise-like pulses is enhanced but the spectrum of the pulses is also broadened due to nonlinear effects in the fiber amplifier. This leads to a reduction of the peak duration in their autocorrelation trace, suggesting a similar extent of pulse compression; by contrast, the pedestal duration increases only slightly, suggesting that the noise-like characteristic is maintained. By controlling the pump power of the fiber amplifier, the compression ratio of the noise-like pulse duration can be adjusted. Due to the pulse compression, supercontinuum generation with a broader spectrum is therefore feasible at a given average power level of the noise-like pulses launched into the highly nonlinear fiber. As a result, supercontinuum generation with an optical spectrum spanning from 1208 to 2111 nm is achieved using a 1-m nonlinear fiber pumped by amplified noise-like pulses of 15.5 MHz repetition rate at an average power of 202 mW.

We demonstrated an all-fiber, high-power noise-like pulse laser system at the 1.56-µm wavelength. A low-power noise-like pulse train generated by a ring oscillator was amplified using a two-stage amplifier, where the performance of the second-stage amplifier determined the final output power level. The optical intensity in the second-stage amplifier was managed well to avoid not only the excessive spectral broadening induced by nonlinearities but also any damage to the device. On the other hand, the power conversion efficiency of the amplifier was optimized through proper control of its pump wavelength. The pump wavelength determines the pump absorption and therefore the power conversion efficiency of the gain fiber. Through this approach, the average power of the noise-like pulse train was amplified considerably to an output of 13.1 W, resulting in a power conversion efficiency of 36.1% and a pulse energy of 0.85 µJ. To the best of our knowledge, these amplified pulses have the highest average power and pulse energy for noise-like pulses in the 1.56-µm wavelength region. As a result, the net gain in the cascaded amplifier reached 30 dB. With peak and pedestal widths of 168 fs and 61.3 ps, respectively, for the amplified pulses, the pedestal-to-peak intensity ratio of the autocorrelation trace remains at the value of 0.5 required for truly noise-like pulses.

No abstract