The ability to efficiently and reliably transfer heat between sources and sinks is often a bottleneck in the thermal management of modern energy conversion technologies ranging from microelectronics to thermoelectric power generation. These interfaces contribute parasitic thermal resistances that reduce device performance and are subjected to thermomechanical stresses that degrade device lifetime. Dense arrays of vertically aligned metal nanowires (NWs) offer the unique combination of thermal conductance from the constituent metal and mechanical compliance from the high aspect ratio geometry to increase interfacial heat transfer and device reliability. In the present work, we synthesize copper NW arrays directly onto substrates via templated electrodeposition and extend this technique through the use of a sacrificial overplating layer to achieve improved uniformity. Furthermore, we infiltrate the array with an organic phase change material and demonstrate the preservation of thermal properties. We use the 3ω method to measure the axial thermal conductivity of freestanding copper NW arrays to be as high as 70 W m(-1) K(-1), which is more than an order of magnitude larger than most commercial interface materials and enhanced-conductivity nanocomposites reported in the literature. These arrays are highly anisotropic, and the lateral thermal conductivity is found to be only 1-2 W m(-1) K(-1). We use these measured properties to elucidate the governing array-scale transport mechanisms, which include the effects of morphology and energy carrier scattering from size effects and grain boundaries.

Thermal phenomena in many biological systems offer an alternative detection opportunity for quantifying relevant sample properties. While there is substantial prior work on thermal characterization methods for fluids, the push in the biology and biomedical research communities towards analysis of reduced sample volumes drives a need to extend and scale these techniques to these volumes of interest, which can be below 100 pl. This work applies the 3ω technique to measure the temperature-dependent thermal conductivity and heat capacity of de-ionized water, silicone oil, and salt buffer solution droplets from 24 to 80 °C. Heater geometries range in length from 200 to 700 μm and in width from 2 to 5 μm to accommodate the size restrictions imposed by small volume droplets. We use these devices to measure droplet volumes of 2 μl and demonstrate the potential to extend this technique down to pl droplet volumes based on an analysis of the thermally probed volume. Sensitivity and uncertainty analyses provide guidance for relevant design variables for characterizing properties of interest by investigating the tradeoffs between measurement frequency regime, device geometry, and substrate material. Experimental results show that we can extract thermal conductivity and heat capacity with these sample volumes to within less than 1% of thermal properties reported in the literature.

No abstract