No abstract

Thermal phenomena in many biological systems offer an alternative detection opportunity for quantifying relevant sample properties. While there is substantial prior work on thermal characterization methods for fluids, the push in the biology and biomedical research communities towards analysis of reduced sample volumes drives a need to extend and scale these techniques to these volumes of interest, which can be below 100 pl. This work applies the 3ω technique to measure the temperature-dependent thermal conductivity and heat capacity of de-ionized water, silicone oil, and salt buffer solution droplets from 24 to 80 °C. Heater geometries range in length from 200 to 700 μm and in width from 2 to 5 μm to accommodate the size restrictions imposed by small volume droplets. We use these devices to measure droplet volumes of 2 μl and demonstrate the potential to extend this technique down to pl droplet volumes based on an analysis of the thermally probed volume. Sensitivity and uncertainty analyses provide guidance for relevant design variables for characterizing properties of interest by investigating the tradeoffs between measurement frequency regime, device geometry, and substrate material. Experimental results show that we can extract thermal conductivity and heat capacity with these sample volumes to within less than 1% of thermal properties reported in the literature.

Phase change materials (PCMs) provide a high energy density for thermal storage systems but often suffer from limited power densities due to the low PCM thermal conductivity. Much like their electrochemical analogs, an ideal thermal energy storage medium combines the energy density of a thermal battery with the power density of a thermal capacitor. Here, we define the design rules and identify the performance limits for rationally-designed composites that combine an energy dense PCM with a thermally conductive material. Beginning with the Stefan-Neumann model, we establish the material design space using a Ragone framework and identify regimes where hybrid conductive-capacitive composites have thermal power densities exceeding that of copper and other high conductivity materials. We invoke the mathematical bounds on isotropic conductivity to optimize and define the theoretical limits for transient cooling using PCM composites. We then demonstrate the impact of power density on thermal transients using copper inverse opals infiltrated with paraffin wax to suppress the temperature rise in kW cm−2 hotspots by ∼10% compared to equivalent copper thin film heat spreaders. These design rules and performance limits illuminate a path toward the rational design of composite phase change materials capable of buffering extreme transient thermal loads.

Silicon (Si) particles are widely utilized as high-capacity electrodes for Li-ion batteries, elements for thermoelectric devices, agents for bioimaging and therapy, and many other applications. However, Si particles can ignite and burn in air at elevated temperatures or under intense illumination. This poses potential safety hazards when handling, storing, and utilizing these particles for those applications. In order to avoid the problem of accidental ignition, it is critical to quantify the ignition properties of Si particles such as their sizes and porosities. To do so, we first used differential scanning calorimetry to experimentally determine the reaction onset temperature of Si particles under slow heating rates (∼0.33 K/s). We found that the reaction onset temperature of Si particles increased with the particle diameter from 805 °C at 20-30 nm to 935 °C at 1-5 μm. Then, we used a xenon (Xe) flash lamp to ignite Si particles under fast heating rates (∼10 to 10 K/s) and measured the minimum ignition radiant fluence (i.e., the radiant energy per unit surface area of Si particle beds required for ignition). We found that the measured minimum ignition radiant fluence decreased with decreasing Si particle size and was most sensitive to the porosity of the Si particle bed. These trends for the Xe flash ignition experiments were also confirmed by our one-dimensional unsteady simulation to model the heat transfer process. The quantitative information on Si particle ignition included in this Letter will guide the safe handling, storage, and utilization of Si particles for diverse applications and prevent unwanted fire hazards.

No abstract