No abstract

No abstract

Fe is considered as a potential candidate for implant materials, but its application is impeded by the low degradation rate. Herein, a dual-phase Fe30Mn6Si alloy was prepared by mechanical alloying (MA). During MA, the motion of dislocations driven by the impact stress promoted the solid solution of Mn in Fe, which transformed α-ferrite into γ-austenite since Mn was an austenite-stabilizing element. Meanwhile, the incorporation of Si decreased the stacking fault energy inside austenite grains, which tangled dislocations into stacking faults and acted as nucleation sites for ε-martensite. Resultantly, Fe30Mn6Si powder had a dualphase structure composed of 53% γ-austenite and 47% εmartensite. Afterward, the powders were prepared into implants by selective laser melting. The Fe30Mn6Si alloy had a more negative corrosion potential of −0.76 ± 0.09 V and a higher corrosion current of 30.61 ± 0.41 μA/cm 2 than Fe and Fe30Mn. Besides, the long-term weight loss tests also proved that Fe30Mn6Si had the optimal degradation rate (0.25 ± 0.02 mm/year).

Fe has immense potential for biodegradable orthopedic applications, but it degrades slowly in the physiological environment. Inducing galvanic couple by alloying Cu to Fe using ball milling is a promising approach. However, the ductile nature of Cu leads to the cold welding of a large amount of Cu powder during ball milling, which makes it difficult to disperse uniformly in the Fe matrix. Here, a Fe−CuO implant with highly dispersed Cu particles in the matrix was developed by shift-speed ball milling and selective laser melting. Specifically, copper oxide (CuO) particles were selected as precursors and dispersed in Fe powders by ball milling since they were brittle and would not be cold-welded during ball milling. After further milling in higher energy, it was found that CuO particles reacted with Fe and generated Cu particles through a stress-activated redox reaction. Subsequently, the obtained powders were prepared into a Fe−CuO implant using selective laser melting. Microstructure examination revealed that the Cu phases in the implant were dispersed evenly in the Fe matrix, which was considered to establish a large number of galvanic couples and aggravated the galvanic corrosion tendency. Electrochemical tests indicated that the implant had improved performance in degradation behavior in terms of high corrosion current density (22.4 μA/cm 2 ), low corrosion resistance (1319 Ω cm 2 ), and good degradation stability. In addition, it presented antibacterial effects against Escherichia coli and Staphylococcus aureus by diffusion mechanisms with killing rates of 90.7 and 96.7%, respectively, as well as good cytocompatibility.