Disordered porous solids, such as heterogeneous catalysts, possess internal void spaces with high degrees of both chemical and geometric heterogeneity. For pore size distributions (PSDs) to be useful void space descriptors for aiding understanding of phenomena such as catalyst activity, their level of accuracy must be known. Due to differences in specific interactions and wetting behavior, the choice of adsorbate can severely impact the accuracy of PSDs derived for disordered materials using gas sorption. Wetting effects in the capillary condensation region have recently been studied extensively by simulation, but there have been no complementary, definitive experimental studies of sorption mechanisms. However, in this work, the novel integrated gas sorption and mercury porosimetry technique has been used to prepare a particular subset of pores, located within the disordered network of a given amorphous material (eg silica or alumina), that had dead-ends with different chemical properties to the walls, and then definitively compare the individual sorption behavior of two different, common adsorbates (nitrogen and argon) within just these pores. The presence of a heavy metal surface was found to lead to a shift to higher pressure in the positions of adsorption and desorption branches and a widening of the hysteresis for argon isotherms for silica pores, but not for alumina pores. In contrast, no such effect was observed for nitrogen. Hence, using argon adsorption rather than nitrogen adsorption was found likely to lead to pore size inaccuracies of at least ∼200% in characterizing silica-supported platinum catalysts, for example. The experimental findings on effects of wetting and pore length were found to be consistent with findings from recent Monte Carlo and MFDFT simulations. Further, analysis of hysteresis widths also suggested that the standard approach using NLDFT would be unsuitable for the type of samples studied here. The results highlight particular issues for the accuracy of PSDs for catalysts consisting of metal nanoparticles supported on oxide materials.
The pore structure of the cathode catalyst layer of proton-exchange membrane (PEM) fuel cells is a major factor influencing cell performance. The nanostructure of the catalyst layer has been probed, using a novel combination of mercury porosimetry with computerised X-ray tomography (CXT), even though the nanopores were below the nominal CXT resolution. The method allows probing of the macroscopic spatial variability in the accessibility of the nanostructure. In particular, mercury entrapment within the catalyst layer showed a pronounced regular spatial patterning corresponding to the already higher X-ray absorbing regions of the fresh catalyst layer. The initial, greater X-ray absorption was due to a higher local concentration of carbon-supported platinum catalyst. This was due to segregation of ionomer away from these areas, caused by the particular screen printing catalyst layer deposition method used, which both enhanced the accessibility of the origin regions and, concomitantly, reduced the accessibility of the destination regions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.