No abstract

This paper focuses on the use of a Lamb wave-based methodology for ultrasound imaging of immersed plate structures. In these cases Lamb waves can be strongly attenuated due to leaky waves and viscous losses in the liquid, but there are low attenuation frequency bands that may be used for NDT applications. Experimental measurements were conducted to validate the existence of these low attenuation frequency bands, which were also theoretically predicted for some propagation modes, between the frequencies-thickness products of 0.5 MHz mm and 9.0 MHz mm. Using a 5 MHz linear-array and phased-array techniques, A1 and S1 modes are used to obtain images of an immersed aluminum plate with artificial defects. The signals are post-processed in order to select the desired propagation mode and to obtain an image with dynamic focusing in reception. While the A1 mode is strongly attenuated, the S1 mode, at 3.4 MHz mm, can be used to detect and localize defects in the immersed plate.

No abstract

Anisotropic materials are widely employed in industry and engineering, and efficient nondestructive testing techniques are important to guarantee the structural integrity of the involved parts. A simple technique is proposed to detect defects in anisotropic plates using ultrasonic guided waves and arrays. The technique is based on the application of an objective threshold to a synthetic aperture image obtained from the instantaneous phase (IP) of the emitter-receiver signal combinations. In a previous work the method was evaluated for isotropic materials, and in this paper it is shown that with some considerations the technique can also be applied to anisotropic plates. These considerations, which should be taken into account in beamforming, are (1) group velocity dependence with propagation direction, and (2) elastic focusing, which results in energy concentration in some propagation directions, with the practical consequence that not all aperture signals effectively contribute to the image. When compared with conventional delay-and-sum image beamforming techniques, the proposed IP technique results in significant improvements relative to defect detection and artifacts/dead zone reduction.

We introduce an intermediate state of the light field which is alternative to the binomial state introduced by Stoler et al, thus interpolating between the number state | n ⟩ and the coherent state | α ⟩. A comparison between their properties shows that the amount of nonclassical effects obtained in the present state can be greater than that obtained in the binomial state, depending on the values of the interpolating parameters and the excitations n and n̄α. Quantum coherence effect exhibited by the present state is also discussed.