Boundary lubrication, in which the rubbing surfaces are coated with molecular monolayers, has been studied extensively for over half a century. Such monolayers generally consist of amphiphilic surfactants anchored by their polar headgroups; sliding occurs at the interface between the layers, greatly reducing friction and especially wear of the underlying substrates. This process, widespread in engineering applications, is also predicted to occur in biological lubrication via phospholipid films, though few systematic studies on friction between surfactant layers in aqueous environments have been carried out. Here we show that the frictional stress between two sliding surfaces bearing surfactant monolayers may decrease, when immersed in water, to as little as one per cent or less of its value in air (or oil). We attribute this to the shift of the slip plane from between the surfactant layers, to the surfactant/substrate interface. The low friction would then be due to the fluid hydration layers surrounding the polar head groups attached to the substrate. These results may have implications for future technological and biomedical applications.

No abstract

We have measured normal and lateral interactions across a range of different liquids between mica surfaces using a surface force balance (SFB). The mica surfaces were prepared either by melt cutting using Pt wire and standard procedures in our laboratories or by tearing sheets (that had not been exposed to Pt) off from a freshly cleaved sheet of mica. AFM micrographs revealed the substantial absence of Pt nanoparticles on the melt cut and torn-off mica surfaces. Normal-force versus surface-separation (D) profiles and shear force versus D measurements for purified water (no added salt), for concentrated aqueous NaCl solutions, and for cyclohexane revealed that in all cases the behavior of the highly confined liquids between melt-cut and between torn-off mica sheets was identical within experimental scatter. These results demonstrate directly that interactions measured between melt-cut mica surfaces as routinely prepared using established procedures in our laboratories and in other laboratories are free of the effect of any Pt contamination.