Hybrid composites have shown innumerable benefits to the research communities in terms of environmental friendliness and mechanical properties. This research study presents the mechanical characterization and moisture uptake of kenaf/pineapple leaf fiber‐reinforced polypropylene hybrid composites with several relative fiber ratios. A comparison was also made between nonhybrid and hybrid kenaf/pineapple leaf fiber‐reinforced composites to investigate the hybridization effect. In this work, the composite materials were fabricated via the hot compression technique. Mechanical tests were performed to obtain the tensile, flexural, and Charpy impact properties of nonhybrid and hybrid kenaf/pineapple leaf fiber‐based composites. The water absorption characteristics were then obtained by immersing the composite materials in the water until the saturation point was reached. The findings concluded that the mechanical properties and moisture uptake behaviors of the composites were improved through the hybridization. The hybrid composites with a relative fiber ratio of 25:75 were particularly promising with the improvement of 10.90% in tensile strength; 16.13% in flexural strength; and 6.80% in impact strength in both flatwise and edgewise orientations compared to nonhybrid kenaf‐based composites. Meanwhile, the diffusion coefficient of hybrid composites (25:75) was 56.12% lower than nonhybrid pineapple leaf fiber‐based composites. Thus, the results indeed demonstrated that the balance between mechanical properties and moisture sensitivity can be obtained through the hybridization of kenaf and pineapple leaf fiber in the composite materials.

No abstract

This study investigates the mechanical properties of high impact polypropylene composite reinforced with pineapple leaf fibre from the Josapine cultivar as a function of fibre loading. PLF was extracted by using a pineapple leaf fibre machine and then an alkaline treatment was conducted to enhance the properties. Samples of the composite were fabricated with 100 mm fibre length with five different fibre loadings of PLF (30, 40, 50, 60 and 70 wt%). The fabrication was made by a compression moulding technique with unidirectional fibre orientation. Related tests such as tensile, hardness and density tests were conducted to determine the effect of fibre loading. The experimental data showed that the composite with the 60 wt% fibre loading offered the highest value of tensile strength, which was about 309%, and the Young's modulus was about 540% compared to 0 wt% of PLF loading. Meanwhile, the hardness and density of the PLF/PP composites showed very similar values, with small increments from 30 wt% up to 70 wt% PLF loading compared to 0 wt% of PLF loading. The highest values are 65.38 Shore-D and 1.002 g/cm³ respectively. The results also revealed that PLF from the Josapine cultivar with alkaline treatment greatly influences the mechanical properties of PLF/PP composite.

No abstract

No abstract