No abstract

Scaffolds were fabricated by electrospinning using polycaprolactone (PCL) blended with poly(methyl methacrylate) (PMMA) in ratios of 10/0, 7/3, 5/5 and 3/7. The PCL/PMMA ratio affected the fiber diameter, contact angle, tensile strength and biological in vitro and in vivo properties of the scaffolds, and the 7/3 ratio resulted in a higher mechanical strength than 5/5 and 3/7. In vitro cytotoxicity and proliferation of MG-63 osteoblast cells on these blended scaffolds were examined by MTT assay, and it was found that PCL/PMMA blends are suitable for osteoblast cell proliferation. Confocal images and expression of proliferating cell nuclear antigen confirmed the good proliferation and expression of cells on the 7/3 PCL/PMMA fibrous scaffolds. In vivo bone formation was examined using rat models, and bone formation was observed on the 7/3 PCL/PMMA scaffold within 2 months. In vitro and in vivo results suggest that 7/3 PCL/PMMA scaffolds can be used for bone tissue regeneration.

A common and prevailing complication for patients with abdominal surgery is the peritoneal adhesion that follows during the post-operative recovery period. Biodegradable polymers have been suggested as a barrier to prevent the peritoneal adhesion. In this work, as a preventive method, PVA/Gelatin hydrogel-based membrane was investigated with various combinations of PVA and gelatin (50/50, 30/70/, and 10/90). Membranes were made by casting method using hot PVA-gelatin solution and the gelatin was cross-linked by exposing UV irradiation for 5 days to render stability of the produced sheathed form in the physiological environment. Physical crosslinking was chosen to avoid the problems of potential cytotoxic effect of chemical crosslinking. Their materials characterization and mechanical properties were evaluated by SEM surface characterization, hydrophilicity, biodegradation rate, and so forth. Cytocompatibility was observed by in vitro experiments with cell proliferation using confocal laser scanning microscopy and the MTT assay by L-929 mouse fibroblast cells. The fabricated PVA/Gel membranes were implanted between artificially defected cecum and peritoneal wall in rats and were sacrificed after 1 and 2 weeks post-operative to compare their tissue adhesion extents with that of control group where the defected surface was not separated by PVA/Gel membrane. The PVA/Gel membrane (10/90) significantly reduced the adhesion extent and showed to be a potential candidate for the anti-adhesion application.

A biodegradable fibrous tube was fabricated by electrospinning method using a combination of Poly(lactic-co-glycolic acid) (PLGA) and gelatin dissolved in trifluoroethanol (TFE). Different ratios of the two polymers (PLGA/Gelatin: 1/9, 3/7, 5/5) were used for electrospinning to determine the optimum condition appropriate for intestinal stent application. Fiber morphology was visualized and analyzed using a scanning electron microscope (SEM). Characterizations of physical properties were done according to its tensile strength, surface hydrophilicity, swelling ability, and biodegradability. Biocompatibility of the scaffolds was investigated in vitro using IEC-18 (Rat intestinal epithelial cell). Cell proliferation was quantified using MTT assay and cell adhesion behavior was visualized by SEM and confocal laser scanning microscope. PLGA/Gelatin (5/5) was determined to have adequate material properties and sufficient in vitro biocompatibility. This was then implanted in a male Sprague-Dawley rat for 14 days to determine in vivo behavior of the sample. Histological examination on the intestinal tissue surrounding the graft showed normal morphology comparable to non-implanted intestine.

Microporous calcium phosphate based synthetic bone substitutes are used for bone defect healing. Different growth factor loading has been investigated for enhanced bone regeneration. The platelet is a cellular component of blood which naturally contains a pool of necessary growth factors that mediate initiation, continuation, and completion of cellular mechanism of healing. In this work, we have investigated the encapsulation and immobilization of platelet-rich plasma (PRP) with natural polymers like hyaluronic acid (HA) and gelatin (Gel) and loading them in a biphasic calcium phosphate (BCP) scaffold, for a synthetic-allologous hybrid scaffold. Effect of PRP addition in small doses was evaluated for osteogenic potential in vitro and in vivo. BCP (10%) mixed HA-Gel hydrogel with or without PRP, was loaded into a BCP sponge scaffold. We investigated the hydrogel-induced improvement in mechanical property and PRP-mediated enhancement in biocompatibility. In vitro studies for cytotoxicity, cell attachment, and proliferation were carried out using MC3T3-E1 pre-osteoblast cells. In in vitro studies, the cell count, cell proliferation, and cell survival were higher in the scaffold with PRP loading than without PRP. However, in the in vivo studies using a rat model, the PRP scaffold was not superior to the scaffold without PRP. This discrepancy was investigated in terms of the interaction of PRP in the in vivo environment.