he increase in antibiotic resistance raises concerns that, at least in some regions, we are returning to a pre-antibiotic era, in particular for Gram-negative infections. The increased prevalence of extended-spectrum serine-β-lactamases (SBLs) and metallo-β-lactamases (MBLs) means β-lactams are increasingly ineffective in treating Gram-negative infections 1,2 . The advent of mobilized colistin resistance-1 in 2015 3 and transferable tigecycline resistance genes (tetX3-tetX5) in 2019 4 , which mediate resistance to colistin and tigecycline, respectively, means all clinically vital antibiotics for serious Gram-negative infections are compromised.

Palladium-catalyzed reactions are among the most commonly used procedures in organic synthesis. The products have a range of uses, including as intermediates in total synthesis and as screening compounds for drug discovery or agrochemical projects. Despite the known and potentially deleterious effects of low-level metal impurities in biological assays, the quantification of metal remaining in reaction products to verify the effective removal of the transition element is rarely reported. Using palladium as an exemplar, we describe a pilot study that for the first time quantifies residual metal levels in reaction products following increasingly rigorous purification protocols. Our results demonstrate that significant levels of residual palladium can remain in isolated reaction products following chromatographic purification, and only by using a subsequent metal scavenging step are they reliably reduced to a low level. Finally, we provide a set of simple guidelines that should minimize the potential for issues associated with residual palladium in reaction products.

Epoxidations (40% aq HBF then m-CPBA) of racemic cis-2-( N-benzylamino)cyclohex-3-en-1-ol and racemic cis-2-( N, N-dibenzylamino)cyclohex-3-en-1-ol proceed with very high levels of diastereoselectivity (>95:5 dr). The latter is in direct contrast to the epoxidation of the corresponding trans-diastereoisomer (which proceeds with essentially no selectivity), showing that the relative configuration of the substrate dramatically influences the diastereoselectivity in these instances. Meanwhile, epoxidations of enantiopure (1 R,2 S,α R)-2-[( N-α-methylbenzyl)amino]cyclohex-3-en-1-ol and (1 S,2 R,α R)-2-[( N-α-methylbenzyl)amino]cyclohex-3-en-1-ol [surrogates for the enantiomers of cis-2-( N-benzylamino)cyclohex-3-en-1-ol] proceed with complete diastereoselectivity (>95:5 dr) under the same conditions, showing that neither the presence of the α-methyl group nor the relative configuration of the α-methylbenzyl stereocenter have an effect upon the established level of diastereoslectivity in these cases. In contrast, epoxidations of enantiopure (1 R,2 S,α R)-2-[ N-benzyl- N-(α-methylbenzyl)amino]cyclohex-3-en-1-ol and (1 S,2 R,α R)-2-[ N-benzyl- N-(α-methylbenzyl)amino]cyclohex-3-en-1-ol [surrogates for the enantiomers of cis-2-( N, N-dibenzylamino)cyclohex-3-en-1-ol] proceed with lower diastereoselectivity (∼70:30 dr). Thus, the presence of the α-methyl group has a detrimental effect on the established level of diastereoselectivity in these cases (although again the relative configuration of the α-methylbenzyl stereocenter is unimportant). The diastereoselective epoxidation pathway is used to enable the asymmetric syntheses of six hitherto unknown, enantiopure dihydroconduramines (+)-C-2, (-)-C-2, (+)-D-2, (+)-E-2, (+)-F-2, and (-)-F-2 (>99% ee in each case).

A method to enable the synthesis of conduramines and their N-substituted derivatives (enantiopure or racemic form) in six steps (five steps for N-substituted derivatives) from cyclohexa-1,4-diene is reported. Key features of this reaction sequence include a preparation of benzene oxide that is amenable to multigram scale, and its efficient ring-opening upon treatment with a primary amine. Epoxidation of the resultant amino alcohols (40% aq HBF4 then m-CPBA) is accompanied by hydrolytic ring-opening in situ to give the corresponding N-substituted conduramine derivatives directly. These may undergo subsequent N-deprotection to give the parent conduramines, as demonstrated by the preparation of enantiopure (−)-conduramine A1, (−)-conduramine A2, and (−)-conduramine E2 (the latter two for the first time). The selectivity of the epoxidation reaction is proposed to be the result of competitive ammonium-directed and hydroxyl-directed epoxidation processes, followed by either direct (SN2-type) or conjugate (SN2′-type) ring-openings of the intermediate epoxides.

Epoxidation of racemic trans-2-(N,N-dibenzylamino)cyclohex-3-en-1-ol, upon treatment with Cl3CCO2H then m-CPBA, proceeded with poor diastereoselectivity (ca. 60:40 dr), whilst epoxidation of racemic trans-2-(N-benzylamino)cyclohex-3-en-1-ol under the same conditions proceeded with high diastereoselectivity (>95:5 dr) and was followed by completely regioselective and stereospecific ring-opening in situ to give, after methanolysis of the intermediate trichloroacetate ester, (1RS,2SR,3SR,4SR)-2-(N-benzylamino)cyclohexane-1,3,4-triol. Use of aq HBF4 as the acid protecting agent gave the amino triol directly. The differing diastereoselectivities of these epoxidation reactions may be due to a predilection towards formation of an intramolecular hydrogen-bond in the former substrate disrupting the ability of the in situ formed ammonium moiety to act as a directing group for the incoming oxidant; the presence of two potential hydrogen-bond donors (i.e., two N–H bonds) in the latter substrate circumvents this limitation. With the criterion for a highly diastereoselective (ammonium-directed) epoxidation in this system established, a synthesis of enantiopure trans-2-(N-benzylamino)cyclohex-3-en-1-ol (>99% ee) was developed and the ammonium-directed epoxidation was then employed as a key synthetic step to facilitate the asymmetric syntheses of enantiopure dihydroconduramines (–)-A-2, (–)-B-2, (–)-C-3 and (+)-F-3 (>98% ee in each case) from 1,3-cyclohexadiene.