[1] In 2003, a massive hydraulic fracturing experiment was carried out at the European Geothermal Hot Dry Rock site at Soultz-sous-Forêts, France. The 2 week injection of water generated a high level of microseismic activity, triggering about 90,000 microearthquakes during and after the fluid injection. Of these, 21,000 events, detected at all stations, were located individually with a grid search algorithm to characterize the extent of the seismic zones and ultimately of the fracture network. The accuracy of these initial locations was around 70 m, not sufficient to map detailed fracture patterns. A precise relocation effort was undertaken to reduce the location uncertainties using three different techniques: joint hypocenter determination (JHD), collapsing and multiplet analysis. The collapsing method was added to the JHD results to further consolidate the hypocenters. On the other hand, a multiplet analysis was performed on the initial data set for identifying microearthquakes with similar waveforms and hence relocating relatively the correlated events. The delays in traveltime were computed by wavelet analysis and the events were relocated using a grid search algorithm. We found 7463 events whose seismograms correlated with a correlation coefficient of 0.8 or higher, most of which were doublets. Multiplets are horizontal tube-like structures with lengths from a hundred to several hundred meters striking along the direction of the maximum compressive horizontal stress. We interpret these structures as the preferential paths where fluid flow is largely confined. This hypothesis is reinforced by the good correlation in depth between the events and the fluid outflows observed in the well. Therefore we believe that these relocated events highlight the zones where the permeability of the reservoir is increased.Citation: Michelet, S., and M. N. Toksöz (2007), Fracture mapping in the Soultz-sous-Forêts geothermal field using microearthquake locations,

No abstract

No abstract

No abstract