No abstract

This paper addresses scaling issues related to small-scale 1-g model tests on plate anchors in sand under drained loading conditions. Previous centrifuge studies from the literature have suggested that the results of conventional 1-g model testing are inaccurate because of scale effects. Other studies have suggested, however, that scaling errors can be reduced in 1-g model tests if the results are presented in dimensionless form and the constitutive response of the model soil is representative of the prototype behavior. There are no experimental studies in the literature that have tested the validity of this approach for plate anchors. A simple 1-g scaling framework was developed for vertically loaded, horizontal plate anchors.Small-scale 1-g model tests were performed on square plate anchors in dry sand, and combined with existing centrifuge and 1-g model test data from the literature to test the scaling approach for both capacity and deformation. The 1-g model tests provided a reasonable representation of the full-scale prototype behavior when the scaling approach was applied.

In recent times, interest in dynamically installed foundation systems for deep-sea construction has increased; however, these foundation systems are still under development and need quantification of various soil parameters with different perspectives. For the design of dynamically installed foundations, it is essential to assess the strain-rate effect on very soft soils. The T-bar has been widely used to characterize soft offshore sediments, such as silt and clay, and there is extensive existing literature on the interpretation of test results. Strain-rate dependence has not previously been fully examined for T-bar tests in very soft clay at very high rates of penetration. This paper examines this aspect using a physical model test. A 65-cm-thick kaolin clay bed was formed using vacuum consolidation. A T-bar was driven into the clay bed at rates that varied from 0.1 cm/s to 60 cm/s. The tests revealed that the resistance factor increased by 9 % for every 10-fold increase in the penetration rate for the material tested in this research.

Offshore wind developments are moving towards deep-water regions where energy is abundant, visual impact is minimised and the larger turbine sizes can make the energy production more cost-effective. One of the key challenges facing the industry is the development of reliable substructures. While fixed foundation systems are widely used for shallow-water (,60 m) developments, permanent anchors are seen as one of the most viable mooring solutions for floating structures in deep water. In the current study, the pull-out behaviour of square plate anchors in clay was investigated using large-displacement finite-element analysis. The anchor capacity and failure mechanism were considered for a range of embedment ratios and undrained shear strengths. Three distinct modes of anchor failure identified in previous studies were examined through the analysis of four descriptors including: the pull-out capacity of the anchor, the pull-out displacement required to mobilise this capacity, the energy absorbed by the anchor during pull-out and the variation of the pull-out capacity with respect to a normalised overburden pressure. The findings of the study are presented in the form of a series of charts that can aid design through understanding of the factors controlling the development of anchor failure modes, in addition to identifying the transition point between different failure mechanisms.