No abstract

No abstract

The antibacterial behaviour of ZnO nanopowder and their composite coatings were investigated against E. Coli. ZnO nanopowder and Aluminum based ZnO composite powders were synthesized using in-house powder processing techniques. Bacteria culture results showed that ZnO nanopowder and their composite powders displayed excellent bacteriostatic activity against E. coli. The antibacterial activity increased with increasing concentration of ZnO nanoparticle in their composite powders as well as increasing surface area of compacted pellets. These nanocomposite powders were subsequently used to generate antibacterial coatings using cold spray technology. The ratio of Al to ZnO in their composite powders were 80:20, 50:50 and 20:80 (wt.%). Microstructural characterization and phase analysis of feedstock powders and as-deposited coatings were carried out using FESEM/EDX and XRD. Antibacterial nanocomposite Al-ZnO coatings were successfully deposited using cold spraying parameters of 15 Bars at air temperature of between 200-300 o C. These assprayed coatings of Al-ZnO composite powders with varying Al and ZnO ratios retained their inherent antibacterial property as verified from bacterial counting test. The results indicated that the antibacterial activity increased with increasing ZnO nanopowder concentration in the composite powder feedstock and cold sprayed coating.

Conventional depth-sending indentation and novel cyclic indentation were performed to study the mechanical properties and strengthening mechanism of pure gold and Ca-doped gold of up to 90 ppm. The system was chosen because it is popular materials for microelectronics interconnection, yet the strengthening mechanism is not well-understood. Conventional depthsensing indentation showed an increase in hardness and modulus of gold with increasing Ca content of up to 90 ppm, which remained significantly higher after annealing. Cyclic depth sensing indentation, where the specimen is loaded to a specific value, unloaded and immediately reloaded, produced a cyclic loop between unloading and reloading curves. The path of the unloading and reloading curves tell the story of the different response of the dislocations generated under the indentation, in different materials, pure gold and Ca-doped gold at different level. Thus their dislocation movement and deformation behavior could be studied by cyclic depth-sensing indentation method. This paper reports cyclic indentation study performed in calcium doped gold widely used in wire bonding and shows that a few ppm level of calcium could result in dislocationssolute interactions, leading to significant strengthening of the materials. TEM micrographs of the material shows that it consists of elongated grains parallel to the drawing direction about 200 nanometers in diameter and a few micrometers in length. It is concluded that cyclic nanoindentation could be used as an extended technique to extract sensitive material information that are not reflected in the conventional test.