No abstract

SUMMARYSystemic dissemination of microbes is critical for progression of many infectious diseases and is associated with most mortality due to bacterial infection. The physical mechanisms mediating a key dissemination step, bacterial association with vascular endothelia in blood vessels, remain unknown. Here, we show that endothelial interactions of the Lyme disease spirochete Borrelia burgdorferi under physiological shear stress mechanistically resemble selectin-dependent leukocyte rolling. Specifically, these interactions are mediated by transfer of mechanical load along a series of adhesion complexes and are stabilized by tethers and catch bond properties of the bacterial adhesin BBK32. Furthermore, we found that the forces imposed on adhesive bonds under flow may be small enough to permit active migration driven by bacterial flagellar motors. These findings provide insight into the biomechanics of bacterial-vascular interactions and demonstrate that disseminating bacteria and circulating host immune cells share widely conserved mechanisms for interacting with endothelia under physiological shear stress.

No abstract

A biodegradable UV-cured resin has been fabricated via stereolithography apparatus (SLA). The formulation consists of a commercial polyurethane resin as an oligomer, trimethylolpropane trimethacrylate (TEGDMA) as a reactive diluent and phenylbis (2, 4, 6-trimethylbenzoyl)-phosphine oxide (Irgacure 819) as a photoinitiator. The tensile strength of the three-dimensional (3D) printed specimens is 68 MPa, 62% higher than that of the reference specimens (produced by direct casting). The flexural strength and modulus can reach 115 MPa and 5.8 GPa, respectively. A solvent-free method is applied to fabricate graphene-reinforced nanocomposite. Porous bone structures (a jawbone with a square architecture and a sternum with a round architecture) and gyroid scaffold of graphene-reinforced nanocomposite for bone tissue engineering have been 3D printed via SLA. The UV-crosslinkable graphene-reinforced biodegradable nanocomposite using SLA 3D printing technology can potentially remove important cost barriers for personalized biological tissue engineering as compared to the traditional mould-based multistep methods.

No abstract