No abstract

A novel synthetic method for the construction of a double-decker silsesquioxane from fluorosilanes was developed. Phenyl-substituted double-decker silsesquioxane was prepared under mild conditions by coupling difluorodiphenylsilane and a tetrasiloxanolate precursor. A similar reaction was performed using difluorovinylsilane, and a divinyl double-decker silsesquioxane was obtained. The one-step reaction of a functional difluorosilane containing an aminopropyl group afforded a novel double-decker silsesquioxane with two amino groups complexed with BF3, which can react with carboxylic acid anhydrides to afford an amide product. This synthetic method using difluorosilane is tolerant of a wide range of functional groups and is applicable to the synthesis of polycyclic silsesquioxanes bearing amino groups, which are difficult to directly obtain from dichlorosilane.

We examined a working hypothesis of sticky thermoelectric (TE) materials, which is inversely designed to mass-produce flexible TE sheets with lamination or roll-to-roll processes without electric conductive adhesives. Herein, we prepared p-type and n-type sticky TE materials via mixing antimony and bismuth powders with low-volatilizable organic solvents to achieve a low thermal conductivity. Since the sticky TE materials are additionally injected into punched polymer sheets to contact with the upper and bottom electrodes in the fabrication process, the sticky TE modules of ca. 2.4 mm in thickness maintained temperature differences of ca. 10°C and 40°C on a hot plate of 40 °C and 120°C under a natural-air cooling condition with a fin. In the single-cell resistance analysis, we found that 75∼150-µm bismuth powder shows lower resistance than the smaller-sized one due to the fewer number of particle-particle interfaces in the electric pass between the upper and bottom electrodes. After adjusting the printed wiring pattern for the upper and bottom electrodes, we achieved 42 mV on a hot plate (120°C) with the 6 x 6 module having 212 Ω in the total resistance. In addition to the possibility of mass production at a reasonable cost, the sticky TE materials provide a low thermal conductivity for flexible TE modules to capture low-temperature waste heat under natural-air cooling conditions with fins for the purpose of energy harvesting.

No abstract

We have developed a new temporary bonding film (TBF) and new debonding system with Xe flash light irradiation, named photonic release system, for advanced package assembly process. Since new TBF has a high Tg over 200 °C after curing and shows good chemical resistance to developer, resist stripper, and plating chemicals, no delamination, voiding, and swelling were observed after thermal and chemical treatment in the bonded structure of wafer and glass carrier. In addition, by adopting a metal-sputtered glass carrier, wafer could be debonded by Xe flash light irradiation in less than 1 ms through the glass carrier with no damage. Residual TBF on the wafer surface could be peeled off smoothly at ambient temperature without residue on the wafer. In this research, we also demonstrated the good applicability of this temporary bonding film to the typical packaging process by using test vehicle including 12 inch mold wafer and the advantage of photonic release system.