No abstract

A large variety of microbial parameter values for nitrifying microorganisms has been reported in literature and was revised in this study. Part of the variety was attributed to the variety of analysis methods applied; it also reflects the large biodiversity in nitrifying systems. This diversity is mostly neglected in conventional nitrifying biofilm models. In this contribution, a one-dimensional, multispecies nitrifying biofilm model was set up, taking into account the large variety of the maximum growth rate, the substrate affinity and the yield of nitrifiers reported in literature. Microbial diversity was implemented in the model by considering 60 species of ammonia-oxidizing bacteria (AOB) and 60 species of nitrite-oxidizing bacteria (NOB). A steady-state analysis showed that operational conditions such as the nitrogen loading rate and the bulk liquid oxygen concentration influence both the macroscopic output as well as the microbial composition of the biofilm through the prevailing concentration of substrates throughout the biofilm. Considering two limiting resources (nitrogen and oxygen), the coexistence of two species of the same functional guild (AOB or NOB) was possible at steady state. Their spatial distribution in the biofilm could be explained using the r- and K-selection theory.

Simple titration methods certainly deserve consideration for on-site routine monitoring of volatile fatty acid (VFA) concentration and alkalinity during anaerobic digestion (AD), because of their simplicity, speed and cost-effectiveness. In this study, the 5 and 8 pH point titration methods for measuring the VFA concentration and carbonate system alkalinity (H2CO3*-alkalinity) were assessed and compared. For this purpose, synthetic solutions with known H2CO3*-alkalinity and VFA concentration as well as samples from anaerobic digesters treating three different kind of solid wastes were analysed. The results of these two related titration methods were verified with photometric and high-pressure liquid chromatography measurements. It was shown that photometric measurements lead to overestimations of the VFA concentration in the case of coloured samples. In contrast, the 5 pH point titration method provides an accurate estimation of the VFA concentration, clearly corresponding with the true value. Concerning the H2CO3*-alkalinity, the most accurate and precise estimations, showing very similar results for repeated measurements, were obtained using the 8 pH point titration. Overall, it was concluded that the 5 pH point titration method is the preferred method for the practical monitoring of AD of solid wastes due to its robustness, cost efficiency and user-friendliness.

The dynamic reactor behaviour of a nitrifying inverse turbulent bed reactor, operated at varying loading rate, was described with a one-dimensional two-step nitrification biofilm model. In contrast with conventional biofilm models, this model includes the competition between two genetically different populations of ammonia-oxidizing bacteria (AOB), besides nitrite-oxidizing bacteria (NOB). Previously gathered experimental evidence showed that different loading rates in the reactor resulted in a change in the composition of the AOB community, besides a different nitrifying performance. The dissolved oxygen concentration in the bulk liquid was put forward as the key variable governing the experimentally observed shift from Nitrosomonas europaea (AOB1) to Nitrosomonas sp. (AOB2), which was confirmed by the developed one-dimensional biofilm model. Both steady state and dynamic analysis showed that the influence of microbial growth and endogenous respiration parameters as well as external mass transfer limitation have a clear effect on the competition dynamics. Overall, it was shown that the biomass distribution profiles of the coexisting AOB reflected the ecological niches created by substrate gradients.

A model describing a given system should be as simple as possible - but not simpler. The appropriate level of complexity depends both on the type of system and on the intended use of the model. This paper addresses the critical question of which purposes justify increased complexity of biofilm (reactor) models. Additional model features compared to conventional models considered are: (1) the inclusion of microbial diversity, distinguishing between different species performing the same function; and (2) the distinction between flocs and granules in putatively granular sludge reactors. With a multispecies model considering interspecies diversity, it was demonstrated that a given macroscopic reactor performance does not necessarily reflect steady state conditions on the microscale. In a second case study, it was shown that the addition of a small level of flocs can have a significant impact on macroscale process performance and on microbial population and activity distributions in granular sludge reactors. It was concluded that increased complexity in biofilm models, concerning microbial diversity or mesoscale aggregate architecture, is likely more useful when the focus is on understanding fundamental microscale outputs, but under specific conditions, these additional model features can be critically informative for bulk reactor behavior prediction and general understanding.